Over 95% pass rate when practice at DMV Practice Test

North Carolina CDL DMV Endorsement Double 2

Take 10 practice tests for CDL is the best way to prepare for your North Carolina DMV exam is by taking our free practice tests. The following question are from real North Carolina DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.

Number of Test
10
Number of Question
20
Passing score
16
13%
  • 0Correct
  • 0Incorrect
Not enough to pass :-(

Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.

1. Belts in the engine compartment should be:
Frayed.
Tight.
Greasy.
Easy to slide off.

When inspecting your vehicle's engine, check the belts for tightness and excessive wear. The amount of "give" that is safe for each belt in a given engine will vary, so learn what is appropriate for your vehicle.

2. Low underneath clearance can cause difficulties when driving:
Over railroad crossings.
On gravel roads.
Around corners.
At the posted speed limit.

Railroad-highway crossings may be difficult to cross if you are pulling a trailer with low underneath clearance. In particular, both low-slung units and single-axle tractors pulling long trailers are especially challenging to drive over raised crossings.

3. Once a coupling is completed, there should be:
Three inches of space between the upper and lower fifth wheel.
No space between the upper and lower fifth wheel.
A moderate amount of space between the upper and lower fifth wheel.

When performing a visual check of coupling devices, you should make sure there is no space between the upper and lower fifth wheel. Ensure that the locking jaws are securely closed around the kingpin.

4. An open automobile window in cold weather may indicate that the driver is:
Driving impaired.
Inappropriately dressed.
Using the heat inside their vehicle.
Enjoying the fresh air.

It is important to observe other drivers' behaviors and identify clues that indicate when person could be driving impaired. Drivers who have had too much to drink, are sleepy, are on drugs, or are ill can present hazards to other drivers. A person driving with their window open in cold weather may be impaired.

5. When parking a double or triple vehicle:
You should back into your parking spot.
You should park on the roadway.
You should park in a location where you can pull forward to exit.
You should ask people to move their vehicles.

When parking a double or triple, you should select a parking spot where you can pull forward when leaving. Be aware of the arrangement of the parking lot to avoid the need for a long and difficult exit.

6. If feeling sleepy while driving, you should:
Press on and finish the trip.
Drive faster to arrive to your destination sooner.
Leave the road and take a nap.
Take an energy pill.

If you begin to feel sleepy while driving, the only safe response is to stop driving and get some sleep. Attempting to fight off exhaustion is dangerous and a major cause of fatal crashes. Stimulants are not a safe solution because they may help keep you awake but will not make you more alert. Once stimulants wear off, you will be even more tired than you were originally.

7. If you have an engine fire, you should:
Open the hood as soon as possible.
Turn off the engine as soon as possible.
Not use a fire extinguisher.

To keep an engine fire from spreading, you should turn off the vehicle's engine as soon as possible. Do not open the hood if you don't have to.

8. Which gas would cause concern due to a faulty exhaust system?
Oxygen
Carbon monoxide
Nitrogen

A leaking exhaust system can introduce carbon monoxide, which is poisonous, into the cab or sleeper berth.

9. Steering wheel play should be no more than:
10 degrees.
25 degrees.
50 degrees.
75 degrees.

Steering wheel play of more than 10 degrees (about two inches of movement at the rim of a 20-inch steering wheel) can make it difficult to steer.

10. An application pressure gauge shows:
How much air pressure is being applied to the brakes.
How much air pressure is available.
How much air pressure is required to stop a vehicle.

If a vehicle is equipped, an application pressure gauge shows how much air pressure is being applied to the brakes. This gauge can help a driver identify if their brakes are beginning to fade.

11. A shut-off valve:
Is located on the front of a trailer.
Is located on the instrument panel.
Prevents air from escaping an air brake system.
Should always be open.

Shut-off valves are used in air supply lines to control the passage of air from one trailer to another. The rear shut-off valve should always be closed to prevent air from leaving the braking system.

12. What tells you how much pressure is in your vehicle's air tanks?
The supply pressure gauge
The ABS malfunction lamp
The tractor protection valve

A vehicle that is equipped with air brakes must also be equipped with a supply pressure gauge. This gauge tells the driver how much air pressure is in each of the vehicle's air tanks.

13. The trailer hand valve should not be used while you are driving because:
It will disconnect from the vehicle.
You will stop the vehicle too quickly.
It can cause a skid.

Never use the trailer hand valve while operating your vehicle. Using the trailer hand valve while driving can cause your trailer to skid.

14. Mirrors should be adjusted:
While moving.
When the trailers are straight.
When you are standing next to the vehicle.
By an assistant.

Mirrors should be checked prior to the beginning of a trip. On a vehicle with a trailer, mirror adjustment can only be checked accurately if the connected trailer is straight.

15. To inspect slack adjusters on S-cam brakes, you need to:
Park on a hill and test the brakes.
Put on gloves and push in the slack adjusters.
Remove the drum and look inside.
Chock the wheels and disengage the parking brake.

Check each slack adjuster after parking on level ground, setting wheel chocks, and disengaging the parking brake. Pull the slack adjusters to make sure they do not move more than about one inch from where the push rod is attached. If they move more than one inch, they may be out of adjustment and will need to be fixed.

16. The application pressure gauge:
Shows how much air pressure is being applied to the brakes.
Shows the temperature of air being used in the braking system.
Shows the pressure of the air coming from the compressor.
Shows the number of times the brakes have been used.

In an air brake system, the application pressure gauge shows how much air pressure is being applied to the brakes. Not all vehicles with an air brake system have this gauge.

17. When only the tractor is equipped with an Anti-Lock Braking System (ABS):
There is a decreased risk of jackknifing.
There is an increased risk of jackknifing.
The brakes will not work as effectively as they would without ABS.
The brakes will become more sensitive.

If a tractor is equipped with an Anti-Lock Braking System (ABS) but the trailer is not, the risk of jackknifing will be reduced and the driver should still be able to maintain steering control. If only the trailer is equipped with ABS, it is less likely that the trailer will swing out to one side.

18. During a static leakage test, what is the maximum leakage rate that is safe for a double combination vehicle?
3 psi in one minute.
6 psi in one minute.
8 psi in one minute.

When performing a static leakage test on a double combination vehicle with air brakes, the leakage rate should be no more than 3 psi in one minute. If the air leaks from the air brake system at a quicker rate, the vehicle should not be driven because something likely needs to be repaired.

19. If a trailer is too high:
It will not make a difference when coupling.
It may not couple correctly.
Coupling will be more secure.
Coupling will be easier.

Before coupling together a tractor and a trailer, you should make sure the trailer is at the proper height. If the trailer is too low, the trailer nose may be damaged. If the trailer is too high, it may not be able to couple correctly.

20. Starting in which year were newly manufactured trailers required to have ABS?
1972
1987
1998
2004

All trailers and converter dollies manufactured on or after March 1, 1998 must be equipped with Anti-Lock Braking Systems (ABS).

Your Progress
  • 0Incorrect (4 allowed to pass)
  • 0Correct
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20