Wyoming CDL DMV Endorsement Passenger 1

When using a fire extinguisher, you should stand as far away from the fire as possible. Aim the extinguisher at the base of the fire, not at the flames. If you are not sure which kind of extinguisher should be used on a fire, particularly a hazardous materials fire, you should wait for the firefighters to arrive and allow them to extinguish it.

Before driving during the winter, make sure to check your defrosting and heating equipment, coolant and antifreeze levels, wipers and washers, tire tread, tire chains, lights, reflectors, and exhaust system. Clear ice and snow from all windows, mirrors, hand holds, steps, deck plates, and radiator shutters. Make sure the winterfront is not closed too tightly.

For safe operation, a commercial motor vehicle needs a tread depth of 4/32 of an inch in every major groove on the front tires, and a tread depth of 2/32 of an inch on other tires.

When backing with a trailer, you should pull up to reposition your vehicle as needed.

Before inspecting the engine compartment, make sure that the parking brakes are on and/or the wheels are chocked. Check the engine compartment before entering the cab and starting the engine.

When using your turn signals, you should signal well before the turn or lane change, signal continuously throughout the turn or lane change, and cancel the signal after you have completed your move.

After changing a tire, you should stop a short distance later to recheck the tightness of the tire's lug nuts.

Most good drivers consistently look down the road 12 to 15 seconds ahead of their vehicles. Watching ahead of your vehicle will allow you to react to upcoming hazards before meeting them.

During the on-road driving test, you must not stop, change gears, pass another vehicle, or change lanes while any part of your vehicle is in a railroad crossing.

A driver uses a look when they open their door, leave their seated position, and walk to the back of the vehicle to check its position. During the straight line backing exercise, a driver may not exceed one look. During any other exercise, a driver may not exceed two looks.

When inspecting a tractor/trailer coupling, look into the fifth wheel gap and make sure the locking jaws are fully closed around the kingpin.

A large vehicle may need to swing right to make a left turn. If an intersection has two left turn lanes, the driver should choose the righthand land to begin their turn.

If you aren't sure that you have room for your vehicle to safely fit under an overhead object, you should slow down while approaching it. Seek an alternate route, if possible.

If your drive wheels begin to spin while accelerating on a surface with poor traction, you should remove your foot from the accelerator.

When inspecting your vehicle, you should verify that the safety belt is securely mounted, adjusts, latches properly, and is not ripped or frayed.

On a bus designed to carry standing passengers, no passengers may stand in front of the rear of the driver's seat. Any such bus must have a line on the floor, or some other marking, that indicates where passengers may not stand. This is called a standee line.

Strategies to reduce the risk of fatigue while driving include getting seven to eight hours of sleep beforehand; scheduling trips for the hours during which you are normally awake; planning to take breaks during the trip; and exercising regularly.

When inspecting your brakes, you should check for cracked drums; shoes or pads covered in oil, grease, or brake fluid; and shoes that are missing, broken, or worn dangerously thin.

You may be asked to complete a parallel parking maneuver into a parking space that is to the left of your vehicle. You should drive past the parking space before backing into it while bringing the rear of your vehicle as close to the rear of the space as possible. Your vehicle should be completely within the boundaries of the space.

Hazardous materials placards must be at least 10 and three-quarter inches square.