Wyoming CAR DMV Practice Test 8

When making a left turn, you should always begin signaling about 100 feet before the turn. You should keep your front wheels aiming straight ahead until it is safe to start your turn. This ensures that you will not be pushed into oncoming traffic if another vehicle hits you from behind.

You should always signal when turning, changing lanes, slowing down, or stopping so that other drivers, motorcyclists, bicyclists, and pedestrians will know your intentions.

A double solid yellow line down the center of a road indicates that traffic is moving in opposite directions and that passing is not allowed from either direction.

Use your right foot for both braking and accelerating. You should apply the brakes gently with increasing pressure so that your vehicle stops gradually and smoothly.

Dashed yellow lines separate single lanes of traffic moving in opposite directions. Passing is allowed when there is no oncoming traffic in the passing lane.

Pedestrians using guide dogs or white canes (with or without a red tip) must be given the right-of-way at all times.

Yellow lane markings indicate a separation of lanes where traffic is traveling in opposite directions. When you see double solid yellow lane markings, passing is prohibited from both directions.

While it can create special problems for large vehicles, strong wind can cause problems for all drivers. Wind can lower visibility by blowing dirt and dust into the roadway, but it can sometimes also physically move a vehicle.

It is not always easy to maintain a safe distance behind your vehicle. However, you can help keep the driver behind you a safe distance away from your vehicle by maintaining a steady speed and signaling turns, lane changes, and deceleration in advance.

While airbags provide supplemental protection for adults in the event of a crash, they pose a severe safety risk for children. Anyone age 12 or under should sit in the back seat of a vehicle with airbags.

Keep a space between your vehicle and parked vehicles. A person may step out of a parked vehicle or out from between the parked vehicles without looking. A driver may begin moving their vehicle before realizing you are there.

Yellow lines mark the center of a road used for two-way traffic. A solid yellow centerline indicates that drivers may not cross the line to pass. A broken yellow centerline indicates that drivers may cross the line to pass, but only if passing would not interfere with traffic.

Because large trucks require more time to accelerate than smaller vehicles, trucks can lose speed driving up long or steep hills. Be cautious when driving behind a large truck and be sure to give the vehicle additional space, especially when driving on an incline.

You need a longer distance to stop your vehicle on a slippery road than you do on a dry road. Maintain an increased following distance when driving on slippery roads.

This sign indicates that you are approaching a railroad crossing. You must look, listen, slow down, and prepare to stop. Wait for any trains to pass before you proceed.

An octagonal sign always means stop. When approaching a stop sign, you must come to a complete stop at the marked stop line and proceed only when it is safe to do so. If there is no stop line, stop before the crosswalk. If there is no crosswalk, stop before the intersection at a point from which you can see any oncoming traffic.

A broken yellow centerline next to your side of the road indicates that traffic may cross the centerline to pass from your side of the road.

When merging onto a freeway, you should enter at or near the speed of traffic.

Even if your light is green, you must not enter an intersection unless you can get completely through the intersection before the light turns red. If you block the intersection, you can be cited.

A solid yellow light means "caution" and signals that the light will soon turn red. You should stop at a solid yellow light if you can do so safely; otherwise, you should cautiously cross the intersection.

A white rectangular sign indicates that you must obey the stated rule. This sign means that drivers should not pass other vehicles for any reason.

Passing areas are based on how far ahead drivers can see. Allow the passing vehicle to re-enter the drive lane as easily as possible to help everyone avoid potential upcoming hazards.

Trees, bushes, or buildings on a corner can block drivers' clear views of the intersection. Approach a blind intersection at a speed no faster than 15 mph.

Make room for vehicles that are entering a freeway. If possible, merge into the next lane to create a gap for the incoming vehicles. If you cannot merge, adjust your speed to allow for the vehicles to enter traffic as smoothly and safely as possible.

Only use your horn when it is necessary to avoid collisions. Do not use your horn if a driver or bicyclist is moving slowly and you want him or her to drive faster or get out of your way.

When parking downhill, turn your front wheels toward the curb or edge of the road. When parking uphill on a road without a curb, turn your wheels toward the edge of the road. When parking uphill on a road with a curb, you must turn your front wheels away from the curb.

When a school bus is flashing its red lights and has its stop arm extended, motorists must come to a full stop until the lights are turned off, the stop arm is withdrawn, and the bus begins moving again.

This sign indicates that U-turns are prohibited. You may see a sign like this at an intersection that commonly has oncoming traffic.

A flashing red traffic light means the same thing as a stop sign. When arriving at an intersection with a flashing red light, you must come to a full stop and proceed when it is safe to do so.

When parking uphill on a road that has a curb, your wheels should be turned away from the curb. When parking uphill on a street without a curb or when parking downhill, your wheels should be turned toward the curb or edge of the road.

Drivers must obey any instructions given by a police officer, even if the instructions contradict laws, signs, signals, or markings that would otherwise apply.

The statewide speed limit on secondary highways is 70 mph. If a different speed limit is posted, you should follow the posted limit.

This sign indicates that the right lane ends ahead. A merging maneuver will be required for drivers in that lane.

A broken yellow line in the center of the road indicates that traffic next to the broken yellow line may pass, if it is safe to do so.

A roundabout is a circular intersection that flows in a counterclockwise direction around a central island and usually does not include a traffic signal. Entering motorists must yield to traffic already in the roundabout, follow the circle to the right, and exit onto their desired roadway.