West Virginia CDL DMV Air Brakes 2
Take 6 practice tests for CDL is the best way to prepare for your West Virginia DMV exam is by taking our free practice tests. The following question are from real West Virginia DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.
- 0Correct
- 0Incorrect
Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.
In an air brake system, the air storage tanks must be drained to remove accumulated water and compressor oil. Failing to do this can cause damage. For example, water that has built up in the system could freeze in cold weather and cause brake failure.
If you are unsure if a trailer is equipped with an Anti-Lock Braking System (ABS), look under the vehicle for the electronic control unit and wheel speed sensor wires coming from the back of the brakes.
If the low air pressure warning light turns on, you should stop and safely park your vehicle as soon as possible. Controlled braking will be possible only as long as enough air remains in the tanks.
The service brake system applies and releases the brakes when a driver presses the brake pedal while driving normally.
A dual air brake system is made up of two separate air brake systems. If there is an air leak in one system, it may not affect the other.
On newer vehicles with air brakes, the parking brake is controlled by a yellow, diamond-shaped knob. The knob is pulled out to set the brakes, and pushed in to release them.
Before driving a vehicle with a dual air brake system, allow time for the air compressor to build up pressure of at least 100 psi in both the primary and secondary systems.
The total stopping distance for vehicles equipped with air brakes is made up of four factors: perception distance, reaction distance, brake lag distance, and braking distance. When braking at a speed of 55 mph while driving on dry pavement, the brake lag can add around 32 feet to a vehicle's total stopping distance.
When pressing the brake pedal in a vehicle with S-cam brakes, air will enter the brake chambers. The added air pressure will push out the rods and move slack adjusters, twisting the brake camshafts.
Some pre-1975 vehicles have a front brake limiting valve, which has "normal" and "slippery" settings. The idea behind these valves was to limit the air pressure available to the front brakes when driving on slippery surfaces, and thereby reduce the danger of a front-wheel skid. Studies have found that this is not actually a concern, so if your vehicle has a front brake limiting valve, leave it in the "normal" position.
Most heavy-duty vehicles use dual air brake systems. A dual air brake system consists of two separate air brake systems, connected by a single set of brake controls. Each system has its own air tanks.
If the low air pressure warning signals activate, it is essential that you bring the vehicle to a safe stop while you are still able to control the brakes.
In an air brake system, a low air pressure warning signal must come on if air pressure in the tanks falls below 60 psi. This warning signal may come in the form of a light, a buzzer, or a wig wag.
If you need to make an emergency stop, you can use either the controlled braking method or the stab braking method. It's important to brake in a way that keeps your vehicle traveling in a straight line while still allowing you to turn, if necessary.
A vehicle that is equipped with air brakes must also be equipped with a supply pressure gauge. This gauge tells the driver how much air pressure is in each of the vehicle's air tanks.
The method of controlled braking involves applying the brakes as hard as you can without locking the wheels. If you need to make large steering adjustments while using controlled braking, you should remove your foot from the brake pedal, steer, then reapply the brakes.
If a tractor is equipped with an Anti-Lock Braking System (ABS) but the trailer is not, the risk of jackknifing will be reduced and the driver should still be able to maintain steering control. If only the trailer is equipped with ABS, it is less likely that the trailer will swing out to one side.
A wig wag is a type of low air pressure warning device in an air brake system. It drops a mechanical arm into the driver's view when the air pressure in the tanks falls below 60 psi.
Brakes heat up with use. If they are overused and become too hot, expansion and chemical changes will make them less effective and eventually cause them to stop working altogether. This is known as "brake fade."
All trucks, truck tractors, and buses must be equipped with emergency brakes and parking brakes. These brakes must be held by mechanical force.
To prevent the build up of oil and water in a vehicle's air tanks, manually operated air tank drains should be used at the end of each day of driving.
When performing a static leakage test on a triple combination vehicle with air brakes, the leakage rate should be no more than 5 psi in one minute. If air leaks from the air brake system at a quicker rate, the vehicle should not be driven because something likely needs to be repaired.
Compressed air in an air brake system usually contains a certain amount of water and compressor oil. The water and oil can damage the brakes if left to accumulate in the system. Manually operated air tank drains must be opened daily to remove this build-up.
The parking brake should be applied every time you park your vehicle.
Most heavy-duty vehicles use dual air brake systems. A dual system has two separate air brake systems with a single set of controls.
Try more CDL West Virginia Practice Test
- 0Incorrect (5 allowed to pass)
- 0Correct