Over 95% pass rate when practice at DMV Practice Test

Vermont CDL DMV Endorsement Double 2

Take 10 practice tests for CDL is the best way to prepare for your Vermont DMV exam is by taking our free practice tests. The following question are from real Vermont DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.

Number of Test
10
Number of Question
20
Passing score
16
13%
  • 0Correct
  • 0Incorrect
Not enough to pass :-(

Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.

1. When near a railroad crossing:
You should expect to hear every approaching train.
You may not hear a train, even if one is approaching.
You will hear two short blasts of a train's horn if a train is approaching.

You should never assume that you will hear an approaching train. The train operator may fail to sound the horn, or the use of a train's horn may be prohibited in a specific area. Even if the train does sound its horn, noise from inside your own vehicle may prevent you from hearing the train until it is dangerously close.

2. If driving through flowing water or a large puddle, you should:
Increase your speed.
Gently apply the brakes.
Try to stop in the water.

It is best to avoid driving through large puddles or moving water. If there is no way to avoid driving through water, you should slow down, shift into a low gear, and gently apply the brakes. Pressing linings against the brake drums or discs will keep water, mud, silt, and sand from getting inside the brake mechanisms.

3. Which of the following is not a reason to use your mirrors?
You are changing lanes.
You are making a turn.
You are looking at fuel prices.

While regular mirror checks should be part of your normal driving routine, checking your mirrors is especially important when turning, changing lanes, merging, and performing tight maneuvers.

4. When driving on a long downhill slope, you should brake by:
Only using the brakes.
Mostly using the brakes and occasionally downshifting.
Downshifting and then using the brakes.

When approaching a long downgrade, you should shift into a lower gear then use proper braking techniques. Using the brakes alone could cause them to overheat and fail. The braking power of the engine, which is maximized by being in a lower gear, will be the principal way of controlling your speed on a downgrade.

5. You should ____ if the low pressure warning signal activates while you are driving.
Stop where you are and park
Exit the roadway as soon as safely possible
Continue driving normally

If the low pressure warning signal activates while you are driving, it is important that you safely exit the roadway as soon as possible and park your vehicle. If the air pressure gets too low, the brakes will no longer work well enough for you to stop safely.

6. Maintaining a cushion of space between your vehicle and the vehicle ahead is:
Not encouraged, as it slows the flow of traffic.
Encouraged, as it allows you time to react to unexpected hazards.
Only encouraged if you are traveling with a passenger.

For safe driving, it is essential that you maintain cushions of space on all sides of your vehicle. This helps to ensure that you will have time to take appropriate action if a problem arises.

7. When coupling:
You can assume all vehicles are the same.
Be sure that you are coupling correctly.
Cracks in the mounting are acceptable.

Incorrect coupling and uncoupling of combination vehicles can have extremely dangerous consequences.

8. When checking power steering hoses during a pre-trip inspection, you should look for:
Leaks.
Secure connections to the battery.
Extra hose pieces available for repairs.

When doing a pre-trip inspection on a vehicle with power steering, be sure to check the hoses, pumps, and fluid level. In particular, you should check the hoses for leaks.

9. If you identify a distracted driver on the road, you should:
Tailgate them.
Flash your lights at them.
Give them plenty of space.

If you encounter a driver who seems distracted on the road, you should give them plenty of room and maintain a safe following distance.

10. The rods in S-cam brakes move the slack adjusters when air pressure is added to the brake chambers. This air pressure is added to the chambers when the driver:
Presses the brake pedal.
Uses the emergency brake.
Uses the trailer hand valve.

When pressing the brake pedal in a vehicle with S-cam brakes, air will enter the brake chambers. The added air pressure will push out the rods and move slack adjusters, twisting the brake camshafts.

11. When you must travel down a hill, when should you switch into a lower gear?
As you begin to move downward
As you go downhill and pick up speed
Before you start going downhill

You should always slow down and shift into a lower gear before starting down a hill. If you do not begin to drive down a hill at a low enough speed, you risk overusing your brakes, causing them to overheat and fade.

12. What tells you how much pressure is in your vehicle's air tanks?
The supply pressure gauge
The ABS malfunction lamp
The tractor protection valve

A vehicle that is equipped with air brakes must also be equipped with a supply pressure gauge. This gauge tells the driver how much air pressure is in each of the vehicle's air tanks.

13. Texting while driving is especially dangerous because:
It is both a mental and physical distraction.
A message may be upsetting to the driver.
People like to read and may become too engaged in their phones.

Texting while driving is particularly dangerous because it is both a mental and physical distraction to the driver. In addition to diverting a driver's mental attention away from the road, texting requires a person to remove at least one hand from the vehicle's controls.

14. You should test the low pressure warning signal by:
Turning on the engine and applying the trailer hand brake.
Rapidly pressing and releasing the brake pedal.
Removing wheel chocks and disengaging the parking brake.

It is essential that your low pressure warning light functions properly. After allowing the system to charge, you can test the warning signal by rapidly applying and releasing the brake pedal. This will release air from the braking system and the warning signal should come on when pressure drops to a dangerous level.

15. When driving a vehicle equipped with an Anti-Lock Braking System (ABS), brakes should be applied:
In the same way as they would be in a vehicle without ABS.
As the vehicle is placed in neutral.
With the hand brake.

When driving a vehicle with ABS, you should brake in the same manner as you would in a vehicle without ABS.

16. If a vehicle is power steering-equipped, the hoses should be:
Checked for leaks.
Securely connected to the battery.
Carrying fuel.

When inspecting a vehicle equipped with power steering, you should inspect the hoses, pumps, and fluid levels. Specifically check the hoses for leaks.

17. How can you check hydraulic brakes?
Pump the brake pedal three times then apply firm pressure to the pedal for five seconds. The brake pedal should not move.
Pump the brake pedal three times then apply firm pressure to the pedal for five seconds. The brake pedal should move slowly toward the floor.
Pump the brake pedal three times then apply firm pressure to the pedal for five seconds. The brake pedal should slowly rise.

Check hydraulic brakes by pumping the brake pedal three times before applying firm pressure to the pedal for five seconds. The pedal should not move. If it does, there may be a leak or some other problem in the braking system.

18. When the wheels of a trailer lock up:
The trailer will be drivable.
The trailer may swing around.
The vehicle will maintain steering.

A trailer may swing out and strike other vehicles if its wheels lock up. This is especially likely with lightly-loaded trailers.

19. What can happen if the air pressure gets too low in an air brake system?
The brakes may squeak.
The brakes may stop working.
The brakes may be sluggish.

Pressing and releasing the brake pedal unnecessarily can let air out of the braking system faster than the compressor can replace it. Air brakes may cease to work effectively if the pressure becomes too low.

20. When trying to put out an electrical fire, you should:
Use water.
Use a B:C extinguisher.
Use an X extinguisher.

B:C fire extinguishers are designed to work on electrical fires and burning liquids. Don't pour water on an electrical fire.

Your Progress
  • 0Incorrect (4 allowed to pass)
  • 0Correct
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20