Utah MOTORCYCLE DMV Practice Test 13
Take 16 practice tests for MOTORCYCLE is the best way to prepare for your Utah DMV exam is by taking our free practice tests. The following question are from real Utah DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.
- 0Correct
- 0Incorrect
Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.
If possible, change lanes and let a tailgater pass your vehicle. Speeding up may result in the driver continuing to tailgate you at a higher speed, thereby increasing the danger.
If your throttle becomes stuck, try twisting it back and forth several times. If this does not free your throttle, immediately operate the engine cut-off switch and pull in the clutch at the same time.
The best way to deal with a tailgater is to let them get in front of you. If you can do so safely, change lanes and let the tailgater pass. Riding faster may only increase the danger by prompting them to continue tailgating you at the higher speed.
Every vehicle registered in the state of Utah, including motorcycles, must pass an annual safety inspection. In addition to a safety inspection, some areas in the state also require an emission test.
When parking a motorcycle next to a curb, you should create at a 90-degree angle with the curb by touching your rear wheel to the curb.
Most motorcycle crashes occur at speeds lower than 30 miles per hour. Even low-speed crashes can be fatal.
To increase your visibility, you can wear clothing that is brightly-colored or that contains reflective materials. Adding auxiliary lights to your motorcycle, using your turn signals, and flashing your brake light when appropriate are also good ways to get the attention of other road users.
Loads should kept low, either fastened securely or in saddlebags. Piling loads against a sissy bar or frame on the back of a seat is dangerous because it can raise the motorcycle's center of gravity and change the balance of the motorcycle. Loads should be equally distributed on both sides of the motorcycle.
There is no one lane position that is always best and no one lane position that should always be avoided. Adjust your lane position in response to changes in road and traffic conditions.
A passenger should lean with the operator through turns and curves. They should sit as far forward as possible, without hindering the operator's control of the motorcycle, and hold onto passenger handholds or the operator's waist, hips, or belt.
To make yourself visible to other road users, you should wear brightly-colored clothing with reflective materials, use your headlight at all times, and use your signals and brake light properly.
If either of your tires go flat while you are riding, hold the handgrips firmly, ease off the throttle, and maintain a straight course. If you need to brake, gradually apply the brake to the tire that is not flat. As you slow down, edge to the side of the road, squeeze the clutch, and stop.
You should use a turn signal every time you plan to turn or change lanes, even if you think no one else is around to see it.
A plastic, shatter-resistant face shield can help protect your whole face if you are involved in a crash. Goggles protect your eyes, but not the rest of your face. A windshield is not an adequate substitute for googles or a face shield.
Longterm exposure to wind and engine noise can cause permanent hearing damage, even if the rider is wearing a full-face helmet. Wearing ear plugs or other hearing protection can guard against damage while still allowing the wearer to hear important sounds like horns and sirens.
The best way to deal with a tailgater is to get them in front of you. If you can do so safely, change lanes and let them pass. Increasing your speed may only encourage the driver to tailgate you at a higher speed.
The weaving motion that occurs when a motorcycle rides over rain grooves or bridge gratings is generally not dangerous. If you experience weaving when riding over one of these surfaces, simply relax and proceed straight across the grooves or gratings at a steady speed. Trying to compensate for the weaving motion by zigzagging is more dangerous than riding straight.
As your weight shifts forward while you are braking, the amount of traction available to the front wheel increases. This means that you can begin to apply the front brake harder.
To maximize your chances of being seen by other road users, you should wear brightly-colored clothing with reflective materials, use your headlight at all times, and use your signals and brake light properly.
In the event of a fall, a motorcyclist can receive protection from a leather jacket, long pants made of heavy denim, and full-fingered gloves. It is best for a motorcyclist to wear lace-up boots, high-top boots, or heavy shoes that support their ankles.
It is recommended that you frequently check your mirrors to be aware of potential hazards behind you.
More than half of all motorcycle crashes involve riders who have been using their motorcycle for less than six months. Most crashes take place in broad daylight when the riders are traveling at low speeds.
Before getting on a motorcycle, you should check the tread and air pressure of the tires, the oil and fluid levels, the lights, and the signals.
When you are being passed from behind or by an oncoming vehicle, stay in the center portion of your lane. Riding any closer to the passing vehicle can put you in danger.
When being passed, it is generally best to ride in the center portion of your lane. Being too close to the passing vehicle increases the risk of a collision.
- 0Incorrect (5 allowed to pass)
- 0Correct