Texas MOTORCYCLE DMV Practice Test 1

Choosing a brightly-colored helmet is recommended. Not only will the helmet protect you in the case of a crash, but the bright color of the helmet will help other road users see you.

All passes must be completed within the posted speed limits and only in areas where passing is permitted.

The accelerator of a motorcycle is located by the right handgrip and is controlled with the right hand.

Because of a passenger's additional weight, a motorcycle will respond more slowly with a passenger on board than with just one occupant. With a passenger, you should travel a bit more slowly than you normally would, start slowing sooner than you normally would, and increase your following distance. Always warn your passenger of any special conditions ahead.

A motorcycle will continue to ride like new if it is properly maintained and routine inspections become a part of its regular maintenance cycle.

It is a good idea to flash your brake light before slowing if someone is following you too closely. The other driver may be focused on you and be unaware of the upcoming hazard that is causing you to slow down. It is also important to flash your brake light if you are about to slow down in a place where other drivers might not expect you to do so.

If your front wheel locks as a result of braking, you should release the front brake immediately and re-apply the brake smoothly.

All motorcycles are slightly different, so you should check the controls and make sure you know the gear pattern before riding an unfamiliar motorcycle. Work the throttle, clutch, and brakes a few times prior to riding.

If either of your tires go flat and you must brake, gradually apply the brake of the tire that is not flat (if you are certain of which tire that is).

The best way to handle a tailgater is to change lanes and let them pass you. Speeding up may cause them to tailgate you at a higher speed, only increasing the danger.

If you accidentally lock the rear brake on a good traction surface, you can keep it locked until you have completely stopped. You should still be able to steer your motorcycle with a locked rear wheel.

The owner's manual should be your primary source of information about your specific type of motorcycle. Be sure to read the manual before operating your motorcycle for the first time.

If one of your tires goes flat, hold both handle grips firmly, ease off of the throttle, and maintain a straight course. If you must brake, gradually apply the brake of the tire that is not flat (if you are certain of which tire that is). As you slow down, edge to the side of the road, squeeze the clutch, and stop.

Before getting on a motorcycle, you should check the tread and air pressure of the tires, the oil and fluid levels, the lights, and the signals.

When passing a row of parked cars, a motorcyclist should be prepared for a parked car to suddenly pull out of a parking space and into traffic. It is often safest for a motorcyclist to ride in the left portion of their lane when passing a row of parked cars on their right to create the most possible space between their motorcycle and any potential hazards.

Gloves should be made of leather or another durable material to provide proper protection for the wearer.

If you cannot avoid hitting an obstacle in the roadway, you should try to hit it at as close to a 90-degree angle as possible. Slow down as much as you can before contact, keep your motorcycle upright, rise slightly off of your seat, and roll the throttle slightly to lighten the front end just before impact.

A motorcycle's single brake light is not as noticeable as the two larger brake lights of a car or truck. It can be a good idea to flash your brake light to help others notice it, especially when you need to slow down more quickly than surrounding drivers may expect.

To reduce the risk of being involved in a crash, you should always ensure that you are visible to others. Communicate your intentions through proper use of your signals, brake light, and lane position. Maintain a space cushion around your motorcycle and consistently scan the road ahead of, behind, and next to your vehicle.

If a hazard requires you to brake and swerve to avoid a collision, you should take the actions separately. Do not brake while swerving because doing so may cause your motorcycle to fall over.