Over 95% pass rate when practice at DMV Practice Test

Tennessee CDL DMV Endorsement Bus 1

Take 10 practice tests for CDL is the best way to prepare for your Tennessee DMV exam is by taking our free practice tests. The following question are from real Tennessee DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.

Number of Test
10
Number of Question
20
Passing score
16
13%
  • 0Correct
  • 0Incorrect
Not enough to pass :-(

Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.

1. Before entering a curve, you should:
Upshift.
Speed up.
Drive on the shoulder.
Downshift.

Always downshift before entering a curve. Decreasing your speed before entering the curve will allow you to maintain better control over the vehicle throughout the curve.

2. Skids caused by over-acceleration can usually be resolved by:
Removing your foot from the accelerator.
Braking.
Swerving to the right.

A skid caused by over-acceleration can be resolved simply by removing your foot from the accelerator. Skids of this nature happen most frequently on surfaces covered in snow or ice.

3. A lane change:
Should be done quickly.
Should be done slowly.
Should be done with a jerking motion.

Lane changes should be made slowly and smoothly.

4. Radial and bias-ply tires:
Should be used together on all axles.
Should be used together, but only on the rear axle.
Should not be used together.

When inspecting your vehicle, ensure that radial and bias-ply tires are not being used together.

5. When completing a conventional parallel parking maneuver, you should:
Back up past the parking space, then pull forward into it.
Pull forward past the parking space, then back into it.
Pull forward directly into the parking space.

You may be asked to complete a conventional parallel parking maneuver into a parking space that is to the right of your vehicle. You should drive past the parking space before backing into it while bringing the rear of your vehicle as close to the rear of the space as possible. Your vehicle should be completely within the boundaries of the space.

6. One way to prevent drowsiness while driving is to:
Drive alone.
Avoid regular exercise.
Get adequate sleep the night before the trip.

Driving while fatigued can be extremely dangerous. Strategies for preventing drowsiness while driving include getting a full night's sleep before a trip; having someone ride with you; scheduling trips for times during which you are normally awake; and avoiding medications that may cause drowsiness. Exercising regularly can increase your energy levels and make you less likely to become tired while driving.

7. When driving in the winter, which of the following should receive extra attention in a pre-trip inspection?
Coolant and antifreeze levels
The air conditioning unit
Oil levels
The air filter

When driving during the winter, it is especially important to make sure the coolant and antifreeze are at safe levels.

8. When pulled off on the side of the road, a driver should:
Keep the driver’s side door open.
Turn on their emergency flashers.
Wave their arms.
Turn off all lights.

If you must stop on the side of the road, it is important that you turn on your emergency flashers as a warning to other drivers. This is especially important if you are stopped at night.

9. What does the vehicle inspection report do?
Inform the motor carrier about problems that may need fixing
Ensure that the vehicle is inspected regularly
Keep people accountable for inspecting the vehicle

A vehicle inspection report keeps the carrier informed about any problems that need to be fixed.

10. While passengers are on board a bus, refueling the bus in an enclosed space, allowing the bus to be towed, and conversing with the passengers are considered to be:
Encouraged practices.
Acceptable practices.
Prohibited practices.

Bus drivers should not engage in conversation with passengers, fuel a bus inside an enclosed building, or tow or push a disabled bus with riders aboard the vehicle. These are all considered to be prohibited practices.

11. When driving with passengers, a bus driver should:
Engage in conversation with the passengers.
Not engage in conversation with passengers.
Ask passengers to watch out the windows for hazards.

To avoid becoming distracted, a bus driver should not engage in conversation with passengers.

12. What eliminates alcohol from the bloodstream?
Coffee
Exercise
Time

The body processes alcohol at a fixed rate that cannot be sped up through tricks like drinking coffee. The only way to sober up is to give the body the time it needs to remove the alcohol on its own.

13. If another driver is tailgating you, you should:
Move into the left lane.
Speed up.
Increase the space in front of your vehicle.
Flash your lights.

If you are being tailgated, it is advisable to open up the space in front of your vehicle, making it easier for the tailgater to get around you. Speeding up may be counterproductive because the driver may continue to tailgate you at the higher speed, only increasing the danger.

14. Cargo on flatbed trailers should be:
Tied down.
Glued down.
Left loose.
Pushed to one side.

Cargo on flatbed trailers or trailers without sides must be tied down to prevent it from shifting or falling in transit.

15. When driving a vehicle equipped with an Anti-Lock Braking System (ABS), you should:
Always pump the brakes several times before holding down the brake pedal.
Brake normally.
Press down the brake pedal as hard as possible every time you slow or stop.

Drivers of vehicles equipped with ABS and drivers of vehicles without ABS should brake in relatively the same manner. When ABS is working properly, it automatically applies when brakes are applied in situations that may create lockup.

16. When you need to change lanes:
Other vehicles will likely get out of your way.
You should change lanes slowly and smoothly.
You should wait to change lanes until you are in an intersection.

Lane changes should always be executed slowly and smoothly. This will result in safer handling of your vehicle while allowing time for other drivers to react to your movements.

17. During a vehicle inspection, be sure that:
The emergency exits are difficult to open.
The emergency exit warning devices work properly.
The emergency exits squeak.
The emergency exits are not accessible from inside the cab.

During the vehicle inspection test, you must ensure that any emergency exit warning devices are working. All emergency exits should operate smoothly, be undamaged, and close securely from the inside.

18. What do headers do?
Protect the driver during a crash
Provide a place for storage
Ensure that controls are accessible
Act as wind guards

Front-end header boards protect the driver from the forward motion of their cargo in the event of a crash or emergency stop.

19. If you’re not sure what to do to extinguish a fire in your vehicle, you should:
Use water.
Stay inside the vehicle.
Wait for the firefighters.

If you are not sure which kind of extinguisher should be used on a fire in your vehicle, particularly a hazardous materials fire, you should wait for the firefighters to arrive and allow them to extinguish it.

20. If pulled off to the side of the road, you should:
Allow your taillights to alert other motorists.
Turn on your emergency flashers to warn other motorists.
Keep your lights off to avoid distracting other motorists.
Keep your door open to warn other motorists.

If you must stop and park on the side of the road, make sure to turn on your emergency flashers. This is especially important at night. Taillights are not an adequate when alerting other drivers because the drivers may mistakenly think your vehicle is moving normally and collide with it.

Your Progress
  • 0Incorrect (4 allowed to pass)
  • 0Correct
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20