South Dakota CDL DMV Endorsement Bus 1
Take 10 practice tests for CDL is the best way to prepare for your South Dakota DMV exam is by taking our free practice tests. The following question are from real South Dakota DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.
- 0Correct
- 0Incorrect
Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.
During the vehicle inspection test, you will need to show emergency equipment, including spare electrical fuses; three red reflective triangles, six fuses, or three liquid burning flares; and a properly charged and rated fire extinguisher.
When driving a school bus, you must activate your four-way flashers while approaching and crossing a railroad crossing. Deactivate the flashers once your entire vehicle has cleared the tracks.
Students should board a school bus slowly and in a single-file line. For safety, boarding students should use the handrail.
If you are asked to alley dock, you should first pull past the alley and stop your vehicle in a position that is parallel to the outer boundary. From there, you should back your vehicle entirely into the alley parking area. Your vehicle should be parked in a straight position within the boundaries of the parking space.
In general, school buses manufactured after 1998 or 1999 must be equipped with an Anti-Lock Braking System (ABS). Many older buses are equipped with ABS as well.
Passive railroad crossings are not controlled by any traffic control devices. At such crossings, it is entirely a driver's responsibility to determine when it is safe to cross the tracks.
During the pre-trip vehicle inspection test, you will be asked to check the power steering, water pump, alternator, and air compressor belts, if the vehicle is equipped.
You will be asked to change lanes during the on-road driving test. When the examiner asks you to do this, you should make the necessary traffic checks and use the proper signals before changing lanes.
On a school bus, the overhead inside rearview mirror is used to monitor passenger activity inside the bus.
Maneuvers that may be included in the basic vehicle control skills test include straight line backing, offset back/right parking, offset back/left parking, driver side parallel parking, conventional parallel parking, and alley docking.
If a school bus becomes stalled or trapped on railroad tracks, the driver should immediately evacuate everyone from the bus. To best avoid flying debris from the bus being struck by a train, the students should be led far away from the bus at an angle that is in the direction of any oncoming train.
During the vehicle inspection test, you must check the power steering belt, water pump belt, alternator belt, and air compressor belt for snugness, cracks, or frays. If any of these components are not belt-driven, you must tell the examiner which one(s), and verify that they are operating properly, mounted securely, and not damaged or leaking.
An Anti-Lock Braking System (ABS) is in place as an addition to a braking system. It intervenes to prevent brakes from locking up during hard braking. If ABS is not working, the basic braking functions on a vehicle will still remain, so the driver can continue to drive and brake normally.
Students should not occupy the back row of a school bus unless the bus is full. The closer to the front of a bus that students are seated, the safer they will be in the event of a rear-end collision. Students with special needs should sit near the driver.
An Ant-Lock Braking System (ABS) helps stop a vehicle's wheels from locking up during hard brake applications.
During the on-road driving skills test, make sure you do not put your vehicle over curbs, sidewalks, or lane markings. Stop behind stop lines, crosswalks, or stop signs. On multiple-lane roads, complete turns in the proper lane. Always move to or remain in the rightmost lane, unless the lane is blocked.
If it is necessary to evacuate a school bus, students should be led by the driver in the direction of oncoming traffic to a safe location that is at least 100 feet off the road. This will help to ensure that they are not hit by flying debris if another vehicle hits the bus.
When crossing railroad tracks during the on-road driving skills test, you must not stop, switch gears, pass another vehicle, or change lanes while any part of your vehicle is in the crossing.
Before a trip, ensure that the steering box is securely mounted. Check for missing nuts, bolts, and cotter keys. Be sure that there are no power steering fluid leaks and that there is no damage to power steering hoses.
Once students have boarded a school bus, the driver should wait to move the bus until all of the passengers are seated and looking forward.
Try more CDL South Dakota Practice Test
- 0Incorrect (4 allowed to pass)
- 0Correct