South Dakota CDL DMV Air Brakes 2

If equipped, ABS is in addition to a vehicle's normal braking system and does not increase or decrease the braking power of any other system. ABS only activates when a vehicle's wheels are about to lock.

In an air brake system, the air compressor pumps air into the air storage tanks. The air compressor is controlled by the air compressor governor.

Some air brake systems include an alcohol evaporator. The evaporator introduces alcohol into the braking system to prevent the formation of ice, which can cause damage.

In a vehicle with a single air brake system, after the engine is at operating rpms, the pressure in the air system should generally build from 50 to 90 psi within three minutes.

Most heavy-duty vehicles use dual air brake systems. A dual air brake system consists of two separate air brake systems, connected by a single set of brake controls. Each system has its own air tanks.

In an air brake system, the air tanks are equipped with drains that allow water and compressor oil to be removed from the system. If allowed to build up, water and compressor oil can damage an air brake system.

Check each slack adjuster after parking on level ground, setting wheel chocks, and disengaging the parking brake. Pull the slack adjusters to make sure they do not move more than about one inch from where the push rod is attached. If they move more than one inch, they may be out of adjustment and will need to be fixed.

An alcohol evaporator can help prevent ice from building up in an air brake system. In cold weather, the evaporator should be checked and refilled every day.

You should not apply the brake pedal if the spring brakes are activated. The brakes could be damaged if they are subjected to the force of air pressure and the springs at the same time.

A modulating control valve allows a driver to gradually apply spring brakes. In equipped vehicles, the valve is controlled by a lever located on the dashboard.

It is important to know the maximum air loss rate that is safe for your specific vehicle. A triple combination should have a leakage rate no higher than 6 psi in a minute during an applied leakage test.

Foundation brakes are used at each wheel. The most common type is the S-cam drum brake.

A modulating control valve allows a driver to gradually apply spring brakes. In equipped vehicles, the valve is controlled by a lever located on the dashboard.

Brakes out of adjustment will fade before those that are properly adjusted. Brake adjustment must be checked frequently to help prevent brake issues.

A vehicle with air brakes must be equipped with a low air pressure warning signal. If the warning signal goes off while a vehicle is being driven, the driver should bring the vehicle to a complete stop and have the system repaired.

Front wheel braking is effective under all road conditions. It is unlikely that you will experience a front wheel skid, even on ice.

Using the brakes excessively will cause them to overheat, making them less effective. This is referred to as "fading."

If the low pressure warning signal activates while you are driving, it is important that you safely exit the roadway as soon as possible and park your vehicle. If the air pressure gets too low, the brakes will no longer work well enough for you to stop safely.

If you use the parking brakes when the weather is very wet and the temperature is below freezing, the brakes may become frozen, preventing the vehicle from moving.

Anti-Lock Braking System (ABS) malfunction lamps are usually yellow. Even if the ABS isn't working properly, a driver will still have access to the vehicle's usual braking functions.

After the brake pedal is pushed down in a vehicle with air brakes, it takes a half-second or more for air to flow through the lines and make the brakes work. This contrasts with hydraulic brakes used in cars and light and medium trucks, which instantly begin working when the pedal is pushed.

You must take an air brakes knowledge test to become licensed to operate a vehicle that is equipped with air brakes, including an air over hydraulic braking system.

Drum brakes are attached to the wheels and located on the axles of a vehicle. The braking mechanisms that cause the vehicle to stop can be found inside of a drum brake.

It is important to know the maximum air loss rate that is safe for your specific vehicle. A triple combination should have a leakage rate no higher than 6 psi in a minute during an applied leakage test.

Compressed air usually contains a certain amount of moisture and compressor oil, which can build up in the air storage tanks and damage the brake system. The tanks should be drained to clean out these accumulations. On a tank with a manual drain valve, draining should be performed at the end of each day of driving.