Over 95% pass rate when practice at DMV Practice Test

Pennsylvania CAR DMV Practice Test 8

Take 24 practice tests for CAR is the best way to prepare for your Pennsylvania DMV exam is by taking our free practice tests. The following question are from real Pennsylvania DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.

Number of Test
24
Number of Question
18
Passing score
14.4
13%
  • 0Correct
  • 0Incorrect
Not enough to pass :-(

Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.

1. When driving in fog:
Use your parking lights.
Use your low beams.
Use your high beams.
It makes no difference which lights you use.

You should use low beam headlights when driving in fog, rain, or snow.

2. If another driver cuts you off in traffic, you should:
Pull next to the driver and yell at them.
Let it go.
Flash your high beams at the driver.
Get back at the other driver by cutting them off.

To avoid the dangers of road rage, you should never take it personally if another driver cuts you off in traffic. Just let it go and continue driving safely.

3. If you stop at a railroad crossing with more than one track:
Wait to proceed until you have a clear view of all tracks.
Stop on the first railroad track and watch for another train.
Go through as soon as the train passes.
Go through when one of the tracks is free.

If you are stopped at a railroad crossing with more than one track, do not start moving as soon as a train passes. Wait until you have a clear view down all tracks before you start across. Even where there is only one track, do not start across immediately after a train passes; check again for another train that may be approaching.

4. If a transit vehicle is signaling to re-enter the main roadway following a stop, you must:
Honk to let them know you’re there.
Move to the left lane.
Yield.
Speed up to pass.

You must yield to any transit vehicle that is signaling to pull back onto the main roadway after it has stopped to load or unload passengers. Change lanes, slow down, or stop to allow the bus safe re-entry into traffic.

5. You must use your headlights when other vehicles are not visible from ____ feet away.
1,000
1,500
1,800
1,200

State law requires you to use your headlights any time you cannot see pedestrians or other vehicles on the highway for a distance of 1,000 feet ahead of your vehicle.

6. You are driving on a highway divided by two solid yellow lines. You may:
Cross these lines only to make a left turn into or from an alley, private road, or driveway.
Cross these lines to pass other vehicles, but only if there is no oncoming traffic.
Cross these lines under no circumstances.
Cross these lines only to make a U-turn.

Double solid yellow lines are used to mark roadways where passing is prohibited from both directions. You may cross these lines only to make a left turn into or from an alley, private road, or driveway.

7. If you are driving near a motorcycle, you must:
Allow the motorcycle to use a complete lane.
Drive on the shoulder beside the motorcycle.
Allow the motorcycle to use only half of a lane.
Pass using the same lane as the motorcycle.

A motorcycle is a full-size vehicle with the same privileges as any other vehicle on the roadway. You should allow a motorcyclist a full lane width. Although it may seem as though there is enough room in the traffic lane for a larger vehicle and a motorcycle, remember that the motorcycle needs room to maneuver safely.

8. If you want to get off the freeway but you have missed your exit, you should:
Go to the next exit.
Make a U-turn through the median.
Pull onto the shoulder and back your car to the exit.
Flag down a police officer for an escort back to your exit.

If you miss your exit, you should take the next exit. Do not stop or back up on the highway, swerve across multiple lanes to try to make the exit at the last second, or cross over the median to turn around. All of these maneuvers are illegal and extremely dangerous.

9. You may drive around the gates at a railroad crossing:
When the train has passed.
Under no circumstances.
When the lights have stopped flashing.
When other drivers drive around the gates.

You are required to stop at all railroad crossings when signals warn of an approaching train. These signals may include flashing red lights, a lowered crossing gate, a flagger signaling, or a train’s audible signal of warning. Do not attempt to go around a lowered gate.

10. Roads freeze quickly when they are:
Flat.
Curvy.
In the sun.
Shaded.

In cold or wet weather, you should take special care on sections of road that are shaded by trees or buildings. These areas freeze more quickly than the rest of the road and are the last parts of the road to dry.

11. A yellow and black diamond-shaped sign:
/data/image/dmv_image/car/washington-warning.png
Warns you about conditions on or near the road.
Helps direct you to cities and towns ahead.
Tells you about traffic laws and regulations.
Tells you about road construction ahead.

Warning signs, which tell you about conditions on or near the road ahead, are usually diamond-shaped with black symbols or words on a yellow background.

12. When traveling at highway speeds on a dry road, a safe following distance is at least:
Three seconds.
Two seconds.
Four seconds.
Two car lengths.

In general, when driving on a dry highway, a four-second following distance will provide adequate time to steer or brake to avoid a hazard.

13. Lanes of traffic moving in opposite directions are divided by ____ lines.
White
Red
Black
Yellow

Yellow lines are used to divide traffic moving in opposite directions.

14. This sign means:
/data/image/dmv_image/car/pennsylvania-no_turn.png
No U-turn.
No turning.
No left turn.
No right turn.

This sign prohibits U-turns. Do not make a U-turn where this sign is posted.

15. A single broken white line down the center of a two-lane road indicates:
Lanes are moving in opposite directions and drivers are not permitted to pass.
Lanes are moving in opposite directions and drivers are permitted to pass when it is safe to do so.
Lanes are moving in the same direction and drivers are not permitted to pass.
Lanes are moving in the same direction and drivers are permitted to pass when it is safe to do so.

White lines are used to separate traffic moving in the same direction. Dashed lines indicate that drivers directly next to the line are permitted to pass when it is safe to do so.

16. After a train has passed, you should:
Check again for approaching trains and proceed with caution.
Wait for a green light.
Immediately proceed across the tracks.
Blow your horn and proceed.

Even at a railroad crossing with only one track, you should not immediately start across after a train has passed. Always check for other approaching trains before proceeding.

17. A flashing red light at a railroad crossing means:
Stop. Do not proceed until signals are deactivated.
Slow down and proceed if the tracks are clear.
Proceed with caution.
You have the right-of-way.

You are required to stop at all railroad crossings when a signal warns of an approaching train. These signals may include flashing red lights, a lowered crossing gate, a flagger signaling, or a train’s audible signal of warning. Do not move forward or attempt to go around any gate or ignore any signal of an approaching train.

18. When you are planning to make a turn, you should activate your turn signals:
Only if there are other drivers following you.
Just as the front of your car reaches the intersection.
Three to four seconds before you reach the intersection.
Two car lengths before reaching the intersection.

To complete a turn safely, you should signal three to four seconds before turning.

Your Progress
  • 0Incorrect (3.6 allowed to pass)
  • 0Correct
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18