Over 95% pass rate when practice at DMV Practice Test

OregonCDLendorsement bus 2

Oregon CDL DMV Endorsement Bus 2

Take 10 practice tests for CDL is the best way to prepare for your Oregon DMV exam is by taking our free practice tests. The following question are from real Oregon DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.

Number of Test
10
Number of Question
20
Passing score
16
13%
  • 0Correct
  • 0Incorrect
Not enough to pass :-(

Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.

Test againNext up practice
1. The area to the left of a school bus is considered especially dangerous to students because:
The sun’s reflection obscures the left side of the bus.
Passing vehicles are located to the left of the bus.
It is difficult to see the left side of any bus.
There is no door on the left side of the bus.

While all sides of a school bus have danger zones, the left side is particularly hazardous to students due to the presence of passing vehicles.

2. School buses:
Are never equipped with ABS.
Are only equipped with ABS if students who are younger than 10 years of age will be on the bus.
May be equipped with ABS.

In general, school buses manufactured after 1998 or 1999 must be equipped with an Anti-Lock Braking System (ABS). Many older buses are equipped with ABS as well.

3. During a basic vehicle control skills test, you may be asked to:
Alley dock.
Parallel park to your right.
Parallel park to your left.
All of the above.

Maneuvers that may be included in the basic vehicle control skills test include straight line backing, offset back/right parking, offset back/left parking, driver side parallel parking, conventional parallel parking, and alley docking.

4. After traveling under an overpass during the driving skills test, you may be asked to recall:
The posted clearance.
The posted weight limit.
The width of the opening.
If there was a shoulder near the roadway.

If you drive under an overpass during the on-road driving skills test, your examiner may ask you to recall the posted clearance or height of the overpass.

5. If a school bus stalls on a railroad track:
Students should remain on the bus.
Students should be evacuated to a location near the bus.
Students should be evacuated and moved away from the bus.

If a school bus becomes stalled or trapped on railroad tracks, the driver should immediately evacuate everyone from the bus. If the bus is struck by a train, to avoid any flying debris, the students should be led far away from the bus at an angle that is in the direction of any oncoming train.

6. The overhead rearview mirror is located:
On the outside left of the bus.
On the outside right of the bus.
Above the windshield inside the bus.

In a school bus, the overhead rearview mirror is mounted directly above the windshield on the driver’s side.

7. Loading and unloading a bus:
Can be hazardous for passengers.
Does not need to be supervised.
Should be done while refueling.

More students are killed each year during loading or unloading of school buses than while riding on school buses. Therefore, it is critical that school bus drivers follow appropriate safety procedures during loading and unloading.

8. An outside convex mirror is properly adjusted if:
The driver can see at least one lane of traffic and the entire side of the bus.
The driver can see the front bumper.
The driver can see the top of the bus.
The driver can see the front windshield.

The outside right and left side convex mirrors on a school bus should be positioned so that the driver can see the fronts of the rear tires touching the ground; each side of the bus up to the mirror mounts; and at least one traffic lane on either side of the bus.

9. Students loading and unloading a bus:
Is simple and does not need to be supervised.
Can be dangerous and should be supervised.
May be done without the bus driver present.

More students are killed each year during loading or unloading of school buses than while riding on school buses. Therefore, it is critical that school bus drivers follow appropriate safety procedures during loading and unloading. This process should never take place without being properly supervised.

10. Backing a school bus is:
Strongly encouraged.
Strongly discouraged.
Only to be done in the morning.

Backing a school bus is strongly discouraged and should only be done if there is no safe alternative. If you must drive in reverse, be sure to follow all proper safety protocol.

11. When performing a pre-trip inspection and looking into the fifth wheel gap, you should:
Make sure there is a gap between the kingpin and the locking jaws.
Make sure the locking jaws are fully closed around the kingpin.
Make sure the locking jaws are loose.

When inspecting a tractor/trailer coupling, look into the fifth wheel gap and make sure the locking jaws are fully closed around the kingpin.

12. As a general rule, student safety is best maintained by:
Keeping the students on the bus.
Letting some students evacuate the bus, while others stay on.
Letting students evacuate the bus.
Creating panic.

In most emergency situations, students will be safest and best kept under control if they do not evacuate the school bus.

13. As students exit the bus, the driver should watch students to ensure that:
They are leaving in pairs.
They do not get caught on the handrail or door.
They do not talk while exiting the bus.
They all have shoes on.

The driver of a school bus should observe students as they enter or exit the bus to ensure that they are not caught in the door or handrails. It is also important to make sure the students have moved a safe distance away from the unloading area after they have exited the bus.

14. If your bus is equipped with a roof-mounted strobe light, it should be used:
In times of limited visibility.
All the time.
Only at night.

If equipped, a school bus's roof-mounted strobe light should be used when conditions create an environment of limited visibility.

15. If a student drops an item while approaching the bus, the student should:
Stop and pick up the object.
Have another student pick up the object.
Ask the driver to pick up the object.
Just leave the item alone and walk away.

It is dangerous for students to retrieve dropped items because doing so could cause them to disappear from the driver's view at a crucial moment. If an item is dropped, the student should get out of the bus's danger zones, get the attention of the driver, and ask the driver to retrieve the item.

16. If your bus has a manual transmission, you should never ____ while crossing railroad tracks.
Change gears
Use the brakes
Look both ways
Listen to flaggers

Before crossing railroad tracks, you should ensure that no trains are approaching from any direction. Never shift gears while crossing railroad tracks.

17. During a vehicle inspection, ensure that lug nuts are all of the following, except:
Free of cracks.
Free of distortions.
Loose.
Free of rust.

During a vehicle inspection test, you must ensure that all lug nuts are present, free of cracks and distortions, and showing no signs of looseness, such as rust trails or shiny threads. Verify that all bolt holes are free of cracks and distortions.

18. During a basic vehicle control skills test, you may be asked to:
Swerve to avoid a hazard.
Parallel park.
Drive straight into a parking space.

Maneuvers that may be included in the basic vehicle control skills test include straight line backing, offset back/right parking, offset back/left parking, driver side parallel parking, conventional parallel parking, and alley docking.

19. When exiting your vehicle, you:
Must maintain four points of contact with the vehicle.
May turn to face the road before your exit is complete.
Must be facing away from the vehicle.
Must be facing the vehicle.

When exiting your vehicle during the basic vehicle control skills test, you must face the vehicle and maintain three points of contact at all times. If your testing vehicle is a bus, you must maintain contact with the handrail. Exiting the vehicle incorrectly may result in automatic failure of the basic control skills test.

20. A properly adjusted flat mirror should allow the driver to see:
The rear tires touching the ground.
The front tires touching the ground.
Only the roadway and no parts of the bus.
The front bumper.

Properly adjusted flat mirrors on a school bus should allow the driver to see 200 feet behind the bus, the base of each rear wheel, and the sides of the bus.

Try more CDL Oregon Practice Test

Your Progress
  • 0Incorrect (4 allowed to pass)
  • 0Correct
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20