North Dakota MOTORCYCLE DMV Practice Test 8

To execute a swerve, press the handgrip on the side of your desired turn. Press on the opposite handgrip to return to your original direction after you are clear of the hazard.

When making a turn, look through the turn to where you want to go. Turn only your head, not your shoulders, and keep your eyes level with the horizon.

A helmet should meet U.S. Department of Transportation (DOT) and state standards and fit snugly all the way around to provide maximum protection. It should be free of defects such as cracks, loose padding, or frayed straps.

Never rely on eye contact as an assurance that a driver will properly yield to you. It is common for drivers to look directly at motorcyclists and still fail to notice them.

To minimize your chances of being in a crash, you should make yourself as visible as possible by wearing brightly-colored clothing when riding, even during the day.

Choose a helmet that meets U.S. Department of Transportation (DOT) and state standards. It should fit you snugly all the way around and be free of obvious defects.

A sidecar is essentially an unpowered mass attached to the side of your motorcycle. Due to its inertia, it will feel like it is lagging behind when you accelerate.

When shifting into a lower gear, shift down one gear at a time and ease out the clutch through the friction zone between each downshift.

There are several advantages to keeping groups of riders small. In comparison to a large group, a small group is easier for other vehicles to pass safely, is less likely to get separated by traffic or stop lights, and creates less need for slower riders to hurry to catch up to the rest of the group.

The engine cut-off switch is generally located next to the right handgrip. It is important to know where all of your motorcycle's controls are located before starting out.

There is no one lane position that is always best and no one lane position that should always be avoided. Adjust your lane position in response to changes in road and traffic conditions.

When you are stopped at an intersection, use your mirrors to check for cars approaching you from behind. The drivers may not notice you until they are too close and you may need to react.

When preparing to pass another vehicle on its left, you should ride in the left portion of the lane to increase your line of sight and make yourself more visible to oncoming traffic.

Oily drippings from cars collect in a strip in the center of a traffic lane. Unless the road is wet, this area will generally still provide enough traction for motorcyclists to ride safely. Because the strip is usually no more than two feet wide, it is often possible to ride to one side of the strip and still be in the center portion of the lane.

As little as one drink can have a significant effect on the abilities that you need for safe riding. You can be impaired even if you are well below the legal blood alcohol limit. No amount of alcohol is safe to consume before riding.

To be sure you are familiar with the specific type of motorcycle that you are planning to ride, read the owner's manual before riding it for the first time. This is particularly important if you are riding a borrowed motorcycle.

Motorcycle brake lights are more difficult to see than the brake lights of larger vehicles, so flashing your brake light may help other drivers to notice it. You should flash you brake light before slowing down where other drivers may not expect you to slow down, such as in the middle of a block or when approaching an alley.

Like any other vehicle, motorcycles have blind spots. Always turn your head to check for traffic in your blind spot before changing lanes.

Experienced riders use a SEE strategy while riding to make safe judgements. "SEE" stands for Search, Evaluate, and Execute.

Hand signals are an important part of communication when riding in groups. A lead rider raising their left arm and extending their index finger means that the group of riders should move into a single-file formation.

Instead of or in addition to mechanical turn signals, operators may use hand signals to indicate turns or stops. If an operator's left arm is bent at the elbow and pointing upward, it means the operator plans to turn right or change lanes to the right.

In comparison to flat mirrors, convex mirrors provide a wider view of the road behind you. They also make objects seem farther away than they actually are. You should practice judging distances in convex mirrors if you are not used to them.

To regain control of a locked rear wheel, the brake must be released. However, if you accidentally lock the rear brake on a good traction surface, you can keep it locked until you have completely stopped.

Before entering a turn, a motorcyclist should reduce their speed by closing the throttle and, if necessary, applying both brakes.

If you accidentally lock the rear brake on a good traction surface, you can keep it locked until you have completely stopped. You should still be able to steer your motorcycle with a locked rear wheel.