New York MOTORCYCLE DMV Practice Test 4

When riding on slippery surfaces, you should use both brakes to slow down. Squeeze the brake lever gradually to avoid locking the front wheel and use gentle pressure on the rear brake.

No single lane position is always best and no single lane position should always be avoided. Adjust your lane position as road and traffic conditions change, choosing a position that will maximize your space cushion and allow other drivers to see you more easily.

Riders in a group should overtake another vehicle one at a time. Each rider should complete their pass and resume their position in the group formation before the next rider begins to pass.

Signs warning operators about hazards or special conditions are usually yellow with black lettering and/or symbols. Always pay attention to the warnings issued by these signs.

Signs informing road users of road regulations, such as speed limits, are normally rectangular and colored white with black lettering or symbols. Riders must follow the rules posted on these regulatory signs.

If you must brake and swerve to avoid a hazard, you should perform both actions separately. Brake then swerve, or swerve then brake. Do not do both at the same time.

Before shifting into a lower gear, make sure you are riding slowly enough to shift safely. Downshifting while going too fast may cause the motorcycle to lurch and the rear wheel to skid. When riding downhill or shifting into first gear, you may need to use the brakes to slow to a safe speed before downshifting.

When riding in a group, inexperienced riders should ride just behind the leader near the front of the group. This allows more experienced riders to keep an eye on them from the back of the group.

Strategies for safely riding at night include reducing your speed, increasing your following distance, using the lights of the car ahead to help see farther down the road, using your high beam headlight (unless following or meeting another vehicle), and being flexible about your lane position.

During normal turns, the motorcycle and the rider should be leaning together at the same angle. In slow, tight turns, only the motorcycle should lean while the rider keeps their body straight up.

A skidding rear tire is a dangerous condition that can result in a violent crash and serious injury or death. Too much rear brake pressure can cause the rear wheel to lock. As soon as the rear wheel locks, your ability to change direction is lost. To regain control, the brake must be released.

A properly chosen lane position can optimize a number of safety factors. Your lane position should keep you out of other vehicles’ blind spots, increase your ability to see and be seen, help you avoid surface hazards, help you avoid wind blasts from other vehicles, and provide you with an escape route from any hazards that might arise. You should be positioned in a way that discourages other drivers from trying to share your lane.

A flashing yellow traffic signal means that operators should proceed with caution. When approaching an intersection controlled by a flashing yellow signal, slow down and look for hazards.

Taking a turn too fast is dangerous. If you cannot hold the turn, you may end up turning into another lane or even off of the road entirely. Use caution when taking a turn.

If you must stop quickly while in a curve, you should first straighten and square the handlebars, then stop. If straightening your motorcycle is not possible, you should apply the brakes smoothly and gradually, reduce your lean angle, then increase the brake pressure as you slow down.

If your throttle becomes stuck, try twisting it back and forth several times. If this does not free your throttle, immediately operate the engine cut-off switch and pull in the clutch at the same time.

If you accidentally lock the rear brake on a good traction surface, keep it locked until you have completely stopped. Even with a locked rear wheel, you should still be able to control your motorcycle if it is upright and traveling in a straight line.

In New York State, a person with a blood alcohol content (BAC) of 0.08 percent or higher is considered legally intoxicated and may not operate a motor vehicle.

Work area signs are orange with black letters and/or symbols. Exercise caution when riding through a work area and take care to follow all instructions provided by signs, signals, or flaggers.

If your motorcycle fits you properly, your feet should be able to reach the ground while you are seated. When riding your motorcycle, keep your feet firmly on the footrests.