Over 95% pass rate when practice at DMV Practice Test

New Mexico CAR DMV Practice Test 2

Take 24 practice tests for CAR is the best way to prepare for your New Mexico DMV exam is by taking our free practice tests. The following question are from real New Mexico DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.

Number of Test
24
Number of Question
25
Passing score
20
13%
  • 0Correct
  • 0Incorrect
Not enough to pass :-(

Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.

1. You should drive on the shoulder to pass a car:
If the vehicle ahead of you is turning left.
Under no circumstances.
If the shoulder is wide enough.

Passing on the right is permissible only if it is possible to do so without driving off the roadway. Never pass another vehicle on the shoulder because the other driver will not expect you to be there and may pull off the road.

2. This road sign means:
/data/image/dmv_image/car/virginia-sharp_right_turn.png
One-way road.
No right turn.
Exit.
Sharp right turn in the road ahead.

This sign indicates that there is a sharp right turn ahead.

3. A traffic light displaying a green arrow and a red light means that:
You may only drive straight ahead.
You may drive only in the direction of the green arrow.
You must wait for a solid green light to proceed in any direction.
Vehicles moving in any direction must stop.

If a green arrow is shown with a red light, you can only drive in the direction of the arrow and only if the intersection is clear.

4. Which of the following are used on some highways to direct drivers into the proper lanes for turning?
Flashing red lights
Flashing yellow lights
White lines on the side of the road
White arrows in the middle of the lanes

Arrows may be used to indicate which lanes should be used for specific purposes, such as driving straight or making a turn.

5. On the freeway, you see a "Merging traffic“ sign. You should:
/data/image/dmv_image/car/washington-merging_traffic.png
Honk at incoming traffic.
Always remain at your present speed.
Speed up to avoid congesting traffic.
Move to another lane, if safe, to let traffic enter.

When on a roadway with two or more lanes, you should make room for entering vehicles. If there is no one driving next to you, move over one lane.

6. When approaching a traffic signal displaying a steady green arrow, drivers:
Should merge into a lane in the direction of the arrow.
Should slow to a stop, if it is safe to do so.
May turn in the direction of the arrow after yielding to traffic and pedestrians already in the intersection.
May drive straight through the intersection.

A green arrow displayed on a traffic signal tells drivers that they may turn in the direction of the arrow. You must be in the proper lane for such a turn. Yield the right-of-way to vehicles and pedestrians already in the intersection.

7. Construction zone signs are generally:
Square or rectangular with white and red coloring.
Round or octagonal with black and yellow coloring.
Diamond-shaped or rectangular with orange and black coloring.

All temporary signs in work zones have an orange background with black letters or symbols. These signs are found on the right side of the road, or on both the left and right sides if the roadway is a divided highway.

8. Use your headlights on rainy, snowy, or foggy days:
To keep your engine warm.
So others can see your vehicle.
To warn others of bad weather conditions.

On rainy, snowy, or foggy days, it may be difficult for other drivers to see your vehicle. Under these conditions, headlights make your vehicle easier to see. If the weather requires you to turn on your windshield wipers, you must also turn on your low beam headlights.

9. Crosswalks are:
Always indicated by horizontal pavement markings.
Always indicated by vertical pavement markings.
Always unmarked.
Either indicated by pavement markings or not marked at all.

Crosswalks exist whether the boundaries are marked or unmarked. You must stop behind the crosswalk to allow any pedestrians to cross.

10. You should honk your horn when you:
Are traveling through an intersection.
Are passing a bicyclist.
See a child who is about to run into the street.
Are parallel parking.

Your horn should be used as a warning in situations where you think another driver or a pedestrian does not see you. For example, if a child begins to run into the street in front of your vehicle, you should sound your horn.

11. When making a right turn on a green light, you must:
Maintain your normal driving speed.
Stop and look for nearby police cars.
Yield to pedestrians.
Increase your normal driving speed.

Unless a posted sign prohibits it, you may turn right or left at a steady green light. When turning, you must yield to other vehicles and pedestrians within the intersection.

12. The presence of double solid yellow lines means you may pass another vehicle from either direction.
TRUE
FALSE

A double solid yellow line means that it is prohibited for vehicles traveling in either direction to cross the centerline to pass.

13. If you reach an intersection where you wish to turn but you are not in the proper lane, you should:
Quickly cut across traffic to make your turn.
Turn on your blinker and make the turn from your current lane.
Drive to the next intersection and make your turn then.
Safely change lanes then put your vehicle in reverse to go back to the intersection.

Never make last-minute turns. If you reach an intersection where you wish to turn but you are not in the proper lane to make the turn, drive to the next intersection and then make the turn from the proper lane.

14. If your wheels drop off the roadway or pavement edge, you should:
Wait until it is safe to do so, then gradually re-enter the roadway.
Turn back onto the roadway immediately.
Stop.

If your wheels drop off the roadway or pavement edge, do not attempt to turn back onto the roadway immediately. Instead, reduce your speed, check traffic, and gradually turn back onto the roadway when it is safe to do so.

15. On a multilane road, a dashed yellow line next to a solid yellow line means:
Passing is prohibited from both directions.
Passing is permitted from both directions.
Passing is permitted only from the direction next to the dashed line.

Where there are both solid and dashed yellow lines between lanes of traffic, only traffic directly next to the dashed line may cross the centerline to pass. Drivers next to the solid line may not pass.

16. If you experience a tire blowout:
Tap or pump the brakes.
Slow down gradually and use your brakes lightly.
Apply the brakes firmly and quickly.

If you experience a tire blowout, you should slow down gradually by taking your foot off of the accelerator. Don't apply the brakes until the vehicle has slowed considerably.

17. When approaching a school bus that is stopped on the opposite side of a divided highway, drivers:
May continue driving.
Must stop until the school bus begins moving.
Must stop until the stop arm is lifted.
Must stop and wait for the flashing lights to stop.

When approaching a school bus that is stopped on the opposite side of a divided highway with its lights flashing and its stop arm extended, drivers may continue driving. If the highway is not separated by a median or divider, drivers on both sides of the street must stop.

18. You are driving on a narrow road when you meet an oncoming vehicle. You must:
Pull completely off the road and stop.
Allow the oncoming vehicle at least one-half of the main-traveled portion of the road.
Demand the other vehicle pull over to make room.
Turn on your high beam headlights to make sure the other vehicle sees you.

On narrow roads, you must allow vehicles traveling in the opposite direction at least one-half of the main-traveled portion of the road. Both vehicles must have adequate space in order for the drivers to safely pass one another.

19. A broken yellow line down the center of a road indicates that:
A construction zone is ahead.
Passing is not permitted from either direction.
Passing is permitted from either direction.

When broken yellow lines separate the lanes of traffic on a two-lane roadway, any driver may pass when there is no oncoming traffic.

20. You come to an intersection with a flashing red light. You must:
Slow down and drive carefully through the intersection.
Turn either right or left, since the road is blocked ahead.
Stop at the intersection and wait for a flashing green light.
Stop at the intersection, then proceed as traffic allows.

A flashing red light means that you must come to a full stop, and then proceed when the way is clear.

21. When driving in bad weather, drivers should:
Increase their speed to reach their final destination more quickly.
Decrease their following distance.
Increase their following distance.
None of the above.

When driving on wet roads, drivers should increase their following distance.

22. Unless otherwise posted, the maximum speed limit on a public highway is:
20 mph.
30 mph.
45 mph.
55 mph.

When driving on a public highway, the maximum speed limit is 55 miles per hour. If a different speed limit is posted, follow the posted speed limit.

23. You may pass another vehicle:
In a curve or on a hill because the chance is small that another vehicle is coming.
By using the shoulder of the highway.
If your lane is next to a solid yellow line and the passing lane is clear ahead.
None of the above.

You may not pass another vehicle on a hill or in a curve because you cannot see oncoming traffic and may cause a collision. Never pass another vehicle by driving onto the shoulder of a highway. Passing another vehicle by driving over a solid yellow line is prohibited.

24. This road sign means:
/data/image/dmv_image/car/maryland-one_way.png
No right turn.
Drive only in the direction of the arrow.
Curve ahead.

Regulatory signs provide notice to road users of traffic laws that must be obeyed. Where this sign is present, drivers must drive in the direction indicated by the arrow.

25. You must not drive your vehicle at a speed greater than:
The maximum speed limit.
A speed that is faster than is reasonable and prudent.
A speed that is safe for existing conditions.
All of the above.

You must not drive at a speed that is faster than is reasonable and prudent. You must drive at a speed that is appropriate for the area where you are driving, the type and condition of surrounding traffic, the presence of pedestrians, the weather, the quality of the road, and light conditions. You must drive within legal speed limits.

Your Progress
  • 0Incorrect (5 allowed to pass)
  • 0Correct
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25