New Jersey CDL DMV Endorsement Bus 1

Crossover mirrors are used to help a driver see the danger zone area directly in front of a school bus, as well as the danger zone areas to the left and right sides of the bus, including the area from the front of the bus to the service door.

When checking the oil pressure gauge as part of a vehicle inspection test, you must ensure that it is working. The gauge should show increasing or normal oil pressure, or the oil pressure warning light should turn off. If equipped with one, the oil temperature gauge should begin a gradual rise to the normal operating range.

Proper mirror adjustment is vital to the safe operation of a school bus. A bus's flat mirrors should be adjusted so the driver is able to see 200 feet, or four bus lengths, behind the bus.

When driving a school bus, you must activate your four-way flashers while approaching and crossing a railroad crossing. Deactivate the flashers once your entire vehicle has cleared the tracks.

If a school bus needs to be evacuated in the event of an emergency, the driver must quickly determine which exit or exits will be safest for students to use and direct the students to that exit.

Students should always board a school bus in a single-file line.

Outside convex mirrors on a school bus are located below the outside flat mirrors. They are used to see a wide view of traffic, clearance, and students around the bus.

During the on-road driving test, you must drive in a safe and responsible manner; wear your safety belt; obey all traffic signs, signals, and laws; and complete the test without any accidents or moving violations.

When exiting your vehicle during the basic vehicle control skills test, you must face the vehicle and maintain three points of contact at all times. If your testing vehicle is a bus, you must maintain contact with the handrail. Exiting the vehicle incorrectly may result in automatic failure of the basic control skills test.

After students have exited a bus at a school, the driver should walk through the bus to check for any remaining students who are hiding or sleeping. Drivers should also look out for items that students may have left behind.

When inspecting an enclosed trailer as a part of the vehicle inspection test, check the front area of the trailer for signs of damage, such as cracks, bulges, or holes.

During the straight line backing exercise, you are permitted to exit your vehicle to check its position no more than one time.

If you must back up a school bus at a student pick-up point, be sure to pick up all students before you begin backing up. When backing, it is especially important to keep an eye out for latecomers.

Once students have boarded a school bus, the driver should wait to move the bus until all of the passengers are seated and looking forward.

If you drive under an overpass during the on-road driving skills test, your examiner may ask you to recall the posted clearance or height of the overpass.

The outside right and left side convex mirrors on a school bus should be positioned so that the driver can see the fronts of the rear tires touching the ground; each side of the bus up to the mirror mounts; and at least one traffic lane on either side of the bus.

Before pulling away from a bus stop, a driver should make sure that there are no students running to catch the bus.

Pre-trip inspections should be conducted in the same way every time. This will reinforce the steps, making it less likely that you will forget to inspect something important.

A school bus driver should never change or add a stop without written approval from the appropriate school district officials.

During the vehicle inspection test, you will need to show emergency equipment, including spare electrical fuses; three red reflective triangles, six fuses, or three liquid burning flares; and a properly charged and rated fire extinguisher.