New Hampshire CDL DMV Endorsement Bus 2

A school bus driver does not have the authority to change the location of a school bus stop. Only appropriate school district officials can determine the locations of bus stops.

When asked to make a turn during the on-road driving test, you must check traffic in all directions and use your turn signal.

During the vehicle inspection test, you must use a tire gauge to check for proper tire inflation. You will not receive passing credit if you simply kick the tires.

Pre-trip inspections should be conducted in the same way every time. This will reinforce the steps, making it less likely that you will forget to inspect something important.

Before pulling away from a bus stop, a driver should make sure that there are no students running to catch the bus.

Passengers may stumble when getting on or off of a school bus. The driver should caution passengers to watch their step when exiting.

If approaching a railroad crossing while driving a transit bus, school bus, or placarded vehicle, special procedures apply. Before crossing, stop your vehicle within 50 feet of, but not less than 15 feet from, the nearest rail. Activate your four-way flashers while crossing. Do not stop, change gears, or change lanes while any part of your vehicle is proceeding across the tracks.

When properly adjusted, the outside side flat mirrors on a school bus should allow the driver to see along the sides of the bus; the rear tires touching the ground; and 200 feet behind the bus.

If you drive over a bridge during the on-road driving skills test, the examiner may ask you afterwards to recall the bridge's posted weight limit.

Once you have stopped as a part of the stop/start maneuver during the on-road driving skills test, you must activate your four-way flashers and shift into neutral or park. You must not block any driveways, intersections, fire hydrants, or signs.

You may be asked to complete a parallel parking maneuver into a parking space that is to the left of your vehicle. You should drive past the parking space before backing into it while bringing the rear of your vehicle as close to the rear of the space as possible. Your vehicle should be completely within the boundaries of the space.

During the vehicle inspection test, you will be asked to do a complete inspection of your vehicle. You will need to explain what you are inspecting and why.

You will be asked to change lanes during the on-road driving test. When the examiner asks you to do this, you should make the necessary traffic checks and use the proper signals before changing lanes.

If you are stopped at a railroad crossing and a gate fails to return to its open position after a train passes, call your dispatcher. Do not attempt to drive around the lowered gate.

During the on-road driving test, the examiner will be scoring you on specific driving maneuvers, as well as your general driving behavior.

In most emergency or crisis situations, students will be safest and easiest to keep under control if they remain on the school bus. Generally, students should be kept on the bus as long as it does not expose them to unnecessary risks or injury.

During emergency situations, it is usually safest for students to remain on a school bus. Evacuations are mandatory if the bus has stalled on railroad tracks, if the bus is on fire or there is a threat of fire, or if there is a hazardous materials spill. Students should be evacuated any time there is imminent danger of collision.

During the on-road driving test, do not stop, change gears, pass another vehicle, or change lanes while any part of your vehicle is in a railroad crossing.

A school bus's long sides are vulnerable to being pushed by winds. If you must drive in windy conditions, you should maintain a strong grip on the steering wheel, try to anticipate wind gusts, and slow down. If necessary, contact your dispatcher for instructions on how to proceed.

When exiting your vehicle during the basic vehicle control skills test, you must face the vehicle and maintain three points of contact at all times. If your testing vehicle is a bus, you must maintain contact with the handrail. Exiting the vehicle incorrectly may result in automatic failure of the basic vehicle control skills test.