Montana MOTORCYCLE DMV Practice Test 16

The owner's manual should be your primary source of information about your specific type of motorcycle. Be sure to read the manual before operating your motorcycle for the first time.

Before riding, you should check the pressure and condition of your tires; check the oil and fluid levels; and make sure that the low beam headlight, high beam headlight, taillight, signal lights, and brake light all work properly.

You will get the greatest amount of protection from a helmet if it meets U.S. Department of Transportation (DOT) and state standards, fits snugly all the way around, and has no obvious defects. A helmet worn at the time of a crash should be replaced.

You can achieve maximum stopping power by using both the front and rear brakes. You should use both brakes every time you slow or stop.

Always use the proper turn signal before a turn or lane change. Use your mirrors and perform head checks before changing lanes to check for traffic surrounding your vehicle.

When passing a row of parked cars, it is generally best to stay on the side of your lane that is not directly next to the cars. This will help to protect you from potential hazards like car doors being opened or people stepping out from between the cars. If there is traffic coming from the opposite direction, it is a good idea to stay in the center portion of the lane.

A staggered formation is the best way to keep ranks close while still maintaining an adequate space cushion for all riders. Ride in a single-file line when riding in curves, turning, or entering or leaving a highway. Never ride side-by-side with another rider.

The throttle of a motorcycle is usually located on the right handle grip. Be sure to know where all of your motorcycle's controls are located before riding.

In Oregon, it is illegal for motorcycles and mopeds to pass between two moving vehicles on a multilane highway or one-way street.

Your first and best protection against collisions with other vehicles is simply to keep your distance from them. The only way to be sure you will have enough time to react to mistakes made by other drivers is to leave plenty of space between you and the vehicles around you. Wearing proper gear is also important when riding a motorcycle.

The only method that effectively reduces your BAC is not drinking alcohol for a period of time. Coffee, exercise, fresh air, and cold showers cannot reduce your BAC or change the effects of alcohol. They can help you remain awake, but they cannot change your BAC or make you sober.

The best way to handle a tailgater is to change lanes and let them pass you. Speeding up may cause them to tailgate you at a higher speed, only increasing the danger.

Because a sidecar sits on the right side of a motorcycle, riding too far to the right side of your lane risks the sidecar running off the road. Similarly, on a three-wheeled motorcycle, the rear right wheel may leave the road if you get too close to the right edge.

Most motorcycle crashes occur at speeds lower than 30 miles per hour. Even low-speed crashes can be fatal.

You should never take eye contact as a guarantee that a driver will properly yield to you. It is not uncommon for drivers to look directly at a motorcyclist but fail to register that they are there.

If you must brake and swerve to avoid a hazard, you should perform both actions separately. Brake then swerve, or swerve then brake. Do not do both at the same time.

The main psychoactive substance in marijuana is called tetrahydrocannabinol, or THC.

Perform an inspection of your motorcycle before every ride. This takes only a few minutes and helps prevent dangerous situations before entering traffic.

When riding in a group, inexperienced riders should ride just behind the leader near the front of the group. This allows more experienced riders to keep an eye on them from the back of the group.

A plastic, shatter-resistant face shield provides protection for the wearer's entire face in the event of a crash. Goggles may protect someone's eyes, but not the rest of their face. A windshield is not an adequate substitute for either.

If one of your tires fails, hold the handgrips firmly and begin to slow down by easing off the throttle while maintaining a straight course. If you must brake, gradually apply the brake of the tire that is still good, if you are sure of which tire that is. Edge toward the side of the road as you slow down, squeeze the clutch, and stop.

If your front wheel locks as a result of braking, you should release the front brake immediately and re-apply the brake smoothly.

You should use your low beam headlight when riding in snowy, rainy, or foggy weather. A high beam headlight can reflect off of these conditions and make it more difficult for a rider to see.

Engine braking by smoothly downshifting can be a useful option for motorcyclists. If you choose to engine brake, apply your brake lights separately to let other drivers know that you are slowing down.

Because most crashes happen in broad daylight, you should always wear brightly-colored clothing while riding, even during the day.