Missouri CDL DMV Endorsement Double 2
Take 10 practice tests for CDL is the best way to prepare for your Missouri DMV exam is by taking our free practice tests. The following question are from real Missouri DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.
- 0Correct
- 0Incorrect
Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.
Distracted drivers perceive hazards on the road more slowly than drivers who are focused, or they do not perceive hazards at all.
Passing parked delivery or postal trucks can be dangerous because the driver may be in a hurry and pull into traffic without warning, or may they suddenly step out of the vehicle without checking for other traffic.
To correct a drive-wheel braking skid, you should first remove pressure from the brake pedal to allow the locked wheels to begin rolling again. Quickly steer in the direction you want to go, then countersteer to prevent your vehicle from skidding in the opposite direction.
Rust around wheel nuts can indicate that the nuts are loose. If you find rust near the wheel nuts, check their tightness before beginning to drive.
To ensure that you can see as well as possible, don't wear sunglasses when driving at night. If you wear eyeglasses, make sure they are clean and unscratched. Make sure you are rested and alert before driving at night.
Ice cream trucks can create hazardous conditions for other drivers because they attract children. Children often do not notice or pay attention to other vehicles on the roadway when running to or from ice cream trucks.
Truck tractors with air brakes built on or after March 1, 1997 are required to be equipped with Anti-Lock Braking Systems (ABS).
Always begin signaling well in advance of a turn. This is the best way to ensure that other drivers do not try to pass you. Without using a turn signal, drivers may assume that you are merely slowing down or stopping when you are planning to turn.
Rollovers happen when an operator turns too fast. Drivers should be sure to slow down before entering turns and curves, especially when pulling a trailer.
Hydroplaning is most likely to occur when driving on wet roads with tire pressure that is too low and tire tread that is too worn. If there is enough water on the road, hydroplaning can occur at speeds as low as 30 mph.
When accelerating, speed up smoothly and gradually so your vehicle does not jerk. Rough acceleration can cause mechanical damage.
If your mirrors or wiper blades become icy while you are driving, you can expect the road surface to be icy as well.
If your brakes are hot after coming down a steep grade, you should not use your parking brake when parking. Let your brakes cool before applying the parking brake or risk damaging the brakes.
The posted speed limit on a curve may be safe to be taken by cars, but can still be too fast to be taken by larger vehicles, such as trucks. An operator driving their truck at the posted limit on a curve could cause their vehicle to tip over.
Hydroplaning is an effect in which a vehicle's tires lose traction with the surface of the road and instead glide along a layer of water. There does not have to be a large amount of water on the road for this to occur.
The function of an Anti-Lock Braking System (ABS) is to help prevent wheel lockup during hard braking. With ABS equipped on your vehicle, you should drive and brake in the same manner that you would without it.
Braking after a tire fails can result in a loss of control. Stay off your brakes, if possible, until your vehicle has slowed considerably.
Lane changes should be made slowly and smoothly.
Black ice is a layer of ice that is thin and clear enough for the road to be visible through it. The surface will look like a wet road. Always be alert to black ice if the road looks wet when the temperature is below freezing.
The most important reason to inspect your vehicle is to ensure the safety of yourself and other road users.
Try more CDL Missouri Practice Test
- 0Incorrect (4 allowed to pass)
- 0Correct