Mississippi MOTORCYCLE DMV Practice Test 8
Take 16 practice tests for MOTORCYCLE is the best way to prepare for your Mississippi DMV exam is by taking our free practice tests. The following question are from real Mississippi DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.
- 0Correct
- 0Incorrect
Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.
On average, a person's body can eliminate the alcohol content of about one drink per hour. The amount of time required to lower a person's blood alcohol content (BAC) can vary, so it is safest not to operate any motor vehicle after consuming any amount of alcohol.
In comparisons to cars and trucks, motorcycles need more frequent attention. A slight technical issue may be extremely dangerous when operating a motorcycle.
Shifting to a lower gear produces an effect similar to applying the brakes. This is known as engine braking.
While a staggered formation is generally recommended, riders in a group should move into a single-file formation when taking curves, taking turns, entering a highway, or leaving a highway.
Wet pavement; roads covered in loose gravel or sand; muddy, snowy, or icy areas; painted lane markings; and metal covers and plates in the road can be slippery surfaces. Motorcyclists should ride with extra caution when riding over slippery surfaces.
If you are following a car, the driver is most likely to notice you if you position yourself behind them in the center of your lane. This lane position places you in the driver's rearview mirror. Most drivers check their rearview mirrors much more frequently than they check their side mirrors.
Appropriate protective gear for motorcycling includes a jacket and pants made of leather or another sturdy material; footwear that covers and supports your ankles; and hearing protection, even if you wear a helmet.
Always use the proper turn signal before a turn or lane change. Use your mirrors and perform head checks before changing lanes to check for traffic surrounding your vehicle.
Because road and traffic conditions are always changing, the safest lane position is also always changing. Choose the position that will maximize your space cushion and allow other drivers to see you most easily.
A properly chosen lane position can optimize a number of safety factors. Your lane position should keep you out of other vehicles’ blind spots, increase your ability to see and be seen, help you avoid surface hazards, help you avoid wind blasts from other vehicles, and provide you with an escape route from any hazards that might arise. You should be positioned in a way that discourages other drivers from trying to share your lane.
You should not rely on eye contact to guarantee that a driver will yield to you. It is not uncommon for a driver to look directly at a motorcyclist and still fail to actually notice them.
The single most important thing you can do to help others see you at an intersection is to ride with your headlight on. Your headlight should be on whenever your motorcycle is running.
The clutch lever of a motorcycle is usually located on the left handgrip.
Long-term exposure to wind noise while riding can cause hearing damage, even if you wear a helmet. Use of proper hearing protection is recommended to prevent damage.
Swerving is a quick maneuver that requires a lot of traction in order to be safely executed. Making sudden moves, such as swerving, on slippery surfaces should be avoided.
You will get the greatest amount of protection from a helmet if it meets U.S. Department of Transportation (DOT) and state standards, fits snugly all the way around, and has no obvious defects. A helmet worn at the time of a crash should be replaced.
To reduce the risk of being involved in a crash, ensure that you are visible to others on the road. Communicate your intentions through your turn signals, brake light, and lane position. Maintain an adequate space cushion, scan your path of travel 12 seconds ahead of your vehicle, and be prepared to act if any hazards arise.
Drippings from cars tend to form an oily strip in the center of each lane. Unless conditions are wet, it is usually still safe for a motorcycle to operate on the center strip.
If a hazard requires you to brake and swerve to avoid a collision, you should take the actions separately. Do not brake while swerving because doing so may cause your motorcycle to fall over.
You should stay well behind the vehicle in front of you, even when you are both stopped. This will give you room to escape if the vehicle backs up unexpectedly or if another vehicle approaches too quickly from behind.
To protect yourself against injury, you should wear a DOT-compliant helmet; face or eye protection; a jacket and long pants made of sturdy material; boots or shoes that are high and sturdy enough to cover and support your ankles; and gloves made of durable material.
While you are braking, gradually increase the amount of pressure applied to the front brake lever as the weight of the bike is transferred forward to the front tire.
Always be very careful when riding a motorcycle that is new to you. In most motorcycle crashes, the operator had less than six months of experience on the bike that they were riding.
The front brake of a motorcycle is more powerful than the rear one, providing at least 70 percent of the total stopping power. Always use both brakes any time you slow or stop.
A properly chosen lane position should help you to see others and be seen by them. Avoid riding in another driver's blind spot for a long period of time.
- 0Incorrect (5 allowed to pass)
- 0Correct