Mississippi MOTORCYCLE DMV Practice Test 14

Crossing rain grooves or bridge gratings may cause your motorcycle to move in a weaving motion. This is usually not dangerous, so simply relax and proceed across the surface at a steady speed. Trying to ride at an angle to compensate for the weave is dangerous because it forces you to zigzag to stay in your lane.

Motorcycles have blind spots just like any other vehicle. Always turn your head and look over your shoulder to check for traffic in your blind spot before changing lanes.

When parking a motorcycle next to a curb, you should create at a 90-degree angle with the curb by touching your rear wheel to the curb.

Instead of or in addition to mechanical turn signals, operators may use hand signals to indicate turns or stops. If an operator's left arm is extended straight out to the left, it means the operator plans to turn left or change lanes to the left.

To reduce the danger of fatigue when riding, dress to protect yourself against tiring weather conditions, such as wind and rain. Limit yourself to no more than about six hours of riding per day and stop for a break at least once every two hours. Avoid taking artificial stimulants since you may experience extreme fatigue when they start to wear off.

A number of surfaces can provide poor traction for tires. Wet pavement; roads covered in loose gravel or sand; muddy, snowy, or icy areas; painted lane markings; oily areas; and metal covers and plates in the road can be more hazardous for a motorcyclist than dry pavement.

When being passed, the center portion of the lane is generally the safest lane position for a motorcyclist. Riding on the side nearest the passing vehicle increases the risk of colliding with it. Riding on the side farthest from the passing vehicle can also be dangerous because it may prompt the driver to return to your lane before it is safe to do so.

A properly chosen lane position should provide a number of benefits, including an increased ability to see others and to be seen. It should help you avoid wind blasts, other drivers' blind spots, and surface hazards. Your lane position should discourage other drivers from trying to share your lane and provide you with an escape route, should a hazard arise. Choose a lane position that maximizes your space cushion.

Your first and best protection against collisions with other vehicles is simply to keep your distance from them. The only way to be sure you will have enough time to react to mistakes made by other drivers is to leave plenty of space between you and the vehicles around you. Wearing proper gear is also important when riding a motorcycle.

Maximum straight-line braking is accomplished by simultaneously applying both the front and rear brakes without locking either wheel.

When riding in a group, you should maintain close ranks but still keep an adequate space cushion around each rider.

Choose a helmet that meets U.S. Department of Transportation (DOT) and state standards. It should fit you snugly all the way around and be free of obvious defects.

To help keep the operator focused on riding, passengers should avoid unnecessary conversation or movement. Passengers should get on a motorcycle only after the engine has been started. They should sit as far forward as they can without crowding the operator and hold firmly onto the operator's waist, hips, or belt.

To be effective, a face shield must be free of scratches; be resistant to penetration; allow clear views to both sides; fasten securely; permit air to pass through; and permit enough room for eyeglasses or sunglasses, if needed.

Always be flexible about your lane position, especially when riding at night. Be especially careful to employ safe riding strategies when riding under conditions that are less than ideal.

Motorcycle brake lights are more difficult to see than the brake lights of larger vehicles, so flashing your brake light may help other drivers to notice it. You should flash you brake light before slowing down where other drivers may not expect you to slow down, such as in the middle of a block or when approaching an alley.

To make yourself visible to others, wearing clothing that is bright orange, red, yellow, or green is best.

If you are not riding slowly enough when shifting into a lower gear, your motorcycle may lurch and the rear tire may skid, causing you to lose control of your motorcycle. Be sure that you are moving slowly enough before shifting into a lower gear.

To ensure that you have a helmet that will provide the best possible protection, you should choose one that meets U.S. Department of Transportation (DOT) standards. It should fit snugly all the way around and have no obvious defects, such as cracks, loose padding, or frayed straps.

While riding in a staggered formation is usually best, a group should switch into a single-file formation when turning, taking curves, or entering or exiting a highway.

Most motorcycle crashes happen on trips shorter than five miles, just a few minutes after the rider starts out.

If you borrow a motorcycle, make all of the same pre-ride safety checks that you would make on your own motorcycle. You should ride cautiously when using an unfamiliar motorcycle and allow yourself extra space when stopping.

You should never take eye contact with another driver as a guarantee that they will properly yield the right-of-way to you.

For your protection, you should wear pants that cover your entire legs and are made of leather or another sturdy synthetic material. Clothing should fit snugly enough that it does not flap in the wind but not so snugly that it restricts your movement.

Wet pavement; roads covered in loose gravel or sand; muddy, snowy, or icy areas; painted lane markings; and metal covers and plates in the road can be slippery surfaces. Motorcyclists should ride with extra caution when riding over slippery surfaces.