Mississippi MOTORCYCLE DMV Practice Test 13

The front brake of a motorcycle is more powerful than the rear brake. It supplies at least three-quarters of the motorcycle's total stopping power.

Conduct a thorough pre-ride inspection before every ride. It should usually take only a few minutes.

The best way to handle a tailgater is to get them in front of you. If you can do so safely, change lanes and let them pass your motorcycle. Speeding up may only increase the danger by prompting them to continue tailgating you at a higher speed.

To reduce the risk of being involved in a crash, you should always ensure that you are visible to others. Communicate your intentions through proper use of your signals, brake light, and lane position. Maintain a space cushion around your motorcycle and consistently scan the road ahead of, behind, and next to your vehicle.

A motorcycle's single brake light is not as noticeable as the two larger brake lights of a car or truck. It can be a good idea to flash your brake light to help others notice it, especially when you need to slow down more quickly than surrounding drivers may expect.

When passing a row of parked cars, a motorcyclist should be prepared for a parked car to suddenly pull out of a parking space and into traffic. It is often safest for a motorcyclist to ride in the left portion of their lane when passing a row of parked cars on their right to create the most possible space between their motorcycle and any potential hazards.

The centermost portion of a lane is where debris and oil drippings from cars often collect. Other hazards, such as utility hole covers, can also be found in the centermost portion of the lane.

The minimum number of drinks left in a person's system can be estimated by subtracting the number of hours since the last drink from the total number of drinks consumed. In this case, the alcohol content of about four drinks would remain.

If your throttle becomes stuck, try twisting it back and forth several times. If this does not free your throttle, immediately operate the engine cut-off switch and pull in the clutch at the same time.

A staggered formation is generally the best way for a group to maintain close ranks while also allowing each rider to maintain an adequate cushion of space. A single-file formation is preferable when taking curves, turning, or entering or exiting a highway.

If one of your tires fails, hold the handgrips firmly and begin to slow down by easing off the throttle while maintaining a straight course. If you must brake, gradually apply the brake of the tire that is still good, if you are sure of which tire that is. Edge toward the side of the road as you slow down, squeeze the clutch, and stop.

A riding jacket and long pants should still be worn when riding in hot weather. In addition to their other safety benefits, they can protect a rider from heat exhaustion and dehydration.

If your front wheel locks, immediately and completely release the front brake. Re-apply the brake smoothly.

In comparisons to cars and trucks, motorcycles need more frequent attention. A slight technical issue may be extremely dangerous when operating a motorcycle.

Do not try to accelerate out of a wobble because doing so will only make the motorcycle more unstable. Instead, grip the handlebars firmly, slow down by gradually closing the throttle, move your weight as far forward and downward as possible, and pull off the road as soon as you can. Avoid applying the brakes, as this may also worsen the wobble.

Goggles can provide protection for your eyes, but only a face shield can protect your entire face. Eyeglasses are not an adequate substitute for either goggles or a face shield.

It is dangerous to ride directly alongside a vehicle in another lane because you may be in the vehicle's blind spot and the driver will have no way of knowing you are there. It can also be dangerous because the vehicle may block your path of escape if another hazard arises.

It is best to entirely avoid slippery stretches of road. However, if there is no way to avoid such an area, keep your motorcycle upright and proceed as slowly as possible.

Give plenty of room to vehicles merging onto a highway from an entrance ramp. Merge into a lane farther away from the entrance ramp, if necessary. If it is not possible to change lanes, adjust your speed to allow room for the vehicle to safely enter the highway.

To ride safely on a slippery surface, you should use both brakes when braking is necessary, reduce your speed, and avoid making sudden moves. Be especially alert to oily areas, shaded areas, dirt, gravel, and bridges, as these surfaces may provide less traction than others.

A person above the legal drinking age with a blood alcohol concentration (BAC) of 0.08 percent or higher is considered legally intoxicated. It is illegal and dangerous to operate a motor vehicle while under the influence of alcohol.

Because a motorcycle handles differently when under the weight of a passenger, an operator should maintain a larger space cushion when transporting another person.

Most drivers do not look at their side mirrors as often as they look at their rearview mirror. Therefore, when following a car, it is generally best to ride in the center portion of the lane where you are most likely to be visible in the driver's rearview mirror.

To make yourself visible to other road users, you should wear brightly-colored clothing with reflective materials, use your headlight at all times, and use your signals and brake light properly.

Some motorcycles are equipped with an Anti-Lock Braking System (ABS). ABS is designed to prevent skidding and wheel lock-up when motorcyclists are stopping in straight-line, panic situations. ABS operates when maximum pressure is applied to both the front and rear brake controls. If electronic sensors detect the possibility of a wheel lock, brake hydraulic pressure is released then re-applied to maintain maximum braking effectiveness.