Mississippi CDL DMV Knowledge Test Class B 2
Take 4 practice tests for CDL is the best way to prepare for your Mississippi DMV exam is by taking our free practice tests. The following question are from real Mississippi DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.
- 0Correct
- 0Incorrect
Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.
When turning on your vehicle's engine, the lights on the dash should come on and then turn off. If the ABS malfunction light stays on, the system is not working properly. In the case of a truck with a trailer, if the yellow light on the left rear of the trailer stays on once the engine has been started, the system is not working properly.
Passing parked delivery or postal trucks can be dangerous because the driver may be in a hurry and pull into traffic without warning, or may they suddenly step out of the vehicle without checking for other traffic.
In an air brake system, air tanks have drains to remove accumulations of water and compressor oil. Allowing water and oil to accumulate in the system could cause damage to the brakes.
If you must stop on the side of the road, it is important to turn on your four-way emergency flashers to warn other road users.
A steering wheel with play of more than 10 degrees may be defective. On a 20-inch wheel, this is equal to about two inches of movement at the rim of the wheel.
If you are unsure of which method is appropriate to use to extinguish a fire, you should wait for firefighters to arrive and let them handle it. This is especially important when dealing with hazardous materials fires.
Pre-trip inspections should be conducted in the same way every time. This will reinforce the steps, making it less likely that you will forget to inspect something important.
Always be sure that you are driving in a manner that will allow your vehicle to come to a complete stop, if necessary, within the area of the road ahead that you are able to see.
Before beginning a trip, it is important to check the brake drums during your walk-around inspection. It is unsafe to drive if any brake drum has a crack more than one half of the width of the friction area.
Driving errors that may be caused by alcohol-induced impairment include straddling lanes; quick, jerky starts; failure to signal or use lights; running stop signs and red lights; and improper passing. A driver's reaction time will become poor when they are under the influence of alcohol.
If you begin to feel tired while driving, the only safe action to take is to stop and get some sleep. Trying to fight the fatigue and press on is very dangerous and can result in a fatal crash. You should not rely on artificial stimulants; these may help keep you awake a while longer, but they won't make you more alert.
Always speed up smoothly and gradually so that your vehicle does not jerk. Rough acceleration can cause mechanical damage.
Applicants seeking a hazardous materials endorsement must undergo a threat assessment conducted by the Transportation Security Administration (TSA).
You should make frequent mirror checks to monitor the traffic around you. This should help you notice if surrounding vehicles begin to move into your blind spots.
Air brakes are really three different braking systems: the service brake, the parking brake, and the emergency brake. Emergency and parking brakes are applied with mechanical force.
A dual air brake system is made up of two separate air brake systems. The systems share a single set of brake controls, but each has its own air tanks, hoses, and lines. One system typically operates the regular brakes on the rear axle or axles while the other system operates the regular brakes on the front axle.
You will be denied a hazardous materials endorsement, or lose an existing endorsement, if you renounce your U.S. citizenship; are not a lawful permanent U.S. resident; are wanted for, indicted for, or convicted of certain felonies; are judged mentally defective or are committed to a mental institution; or are deemed by the Transportation Security Administration (TSA) to pose a security threat.
During the basic vehicle control skills test, you must place the vehicle in neutral and set the parking brake before exiting the vehicle to check its position. You may check the position of the vehicle no more than twice, except during the straight line backing exercise, where you may look no more than once.
The function of an Anti-Lock Braking System (ABS) is to help prevent wheel lockup during hard braking. With ABS equipped on your vehicle, you should drive and brake in the same manner that you would without it.
An encroachment during the basic vehicle control skills test is when an exercise boundary line is touched or crossed by any portion of the applicant's vehicle. Every encroachment will be counted as an error.
Posted speed limits on exit and entrance ramps often show speeds that are safe to be driven by cars. However, these speed limits may be too fast for large or heavily-loaded vehicles and CMV drivers will likely need to slow down to a speed below the posted limit.
The weight of cargo in a vehicle should be distributed as low as possible. Having a center of gravity that is too high will increase the risk of a rollover.
The securement of cargo must be checked before beginning a trip, within the first 50 miles of a trip, and then again every three hours or 150 miles thereafter.
A large vehicle may need to swing right to make a left turn. If an intersection has two left turn lanes, the driver should choose the righthand land to begin their turn.
An air brake system has a safety relief valve, which releases air from the tanks if the pressure gets too high. If the valve must operate, something in the system is wrong and should be addressed by a mechanic.
Parking brakes should not be used in very wet weather when temperatures are below freezing. The brakes could become frozen in place, making it impossible to move the vehicle.
When a vehicle is traveling on a downward slope, the force of gravity will cause its speed to increase.
Vehicles equipped with Anti-Lock Braking Systems (ABS) have yellow malfunction lights to indicate issues in the braking system.
You may be able to tell that another driver is distracted if you can see them drifting within a lane or across lane dividers; traveling at inconsistent speeds; being preoccupied with a cell phone, a map, food, or other items; or engaging in conversation with passengers.
Defects in an exhaust system are very dangerous because they can cause poisonous fumes to enter the cab or sleeper berth.
To warn drivers behind you that you are about to slow down, it may be a good idea to first lightly tap your brake pedal a few times to make the brake lights flash.
The height of a vehicle's center of gravity is very important to a driver's ability to safely handle the vehicle. Always distribute the weight of cargo as low as possible.
During the on-road driving test, the examiner will be score you on specific driving maneuvers as well as on your general driving behavior. You must drive in a safe and responsible manner; obey all traffic signs, signals, and laws; and not cause an accident or commit a moving violation.
When driving a school bus, you must activate your four-way flashers while approaching and crossing a railroad crossing. Deactivate the flashers once your entire vehicle has cleared the tracks.
Proper loading of cargo is essential for safety. Cargo that is not properly secured could fall off and cause death or injury. Excessive or inappropriate loading could damage a vehicle, and make it hard for a driver to steer safely.
Try more CDL Mississippi Practice Test
- 0Incorrect (7 allowed to pass)
- 0Correct