Michigan CDL DMV Endorsement Bus 2

Crossover mirrors are used to help a driver see the danger zone area directly in front of a school bus. The mirrors should also display the danger zone areas to the left and right sides of the bus, including the area from the front of the bus to the service door.

A bus should not be refueled while passengers are on board unless it is absolutely necessary to do so. In particular, a bus with riders on board should never be refueled inside an enclosed building.

When approaching a railroad crossing, buses should stop between 15 and 50 feet from the nearest track and the driver should look both ways for a train. They should open the forward door if it improves their ability to see or hear an oncoming train.

You should always check the adjustment of all your mirrors before operating a school bus.

A school bus driver should not attempt to move a student who has suffered a neck or spinal injury unless the student's life is in immediate danger.

The overhead inside rearview mirror in a school bus is used to monitor passenger activity inside the bus.

The top portion of the overhead inside rearview mirror should be positioned to display the top of the bus's rear window. This mirror positioning should allow the driver to see all of the students on the bus, including the heads of the students sitting immediately behind the driver.

When unloading students at a school, a bus driver must secure the bus by turning off the engine. If they must leave the driver's compartment, they should remove the key from the ignition. The driver must supervise the unloading process.

On a bus, it is permissible to lock some emergency roof hatches in an open position to allow in fresh air. However, this should not be a regular practice.

Backing in a school bus is strongly discouraged and should be done only if there is no other safe way to move the vehicle. If you must drive in reverse at a student pick-up point, you should wait until all students have first loaded the bus.

Backing a school bus is strongly discouraged and should only be done if there is no safe alternative. If you must drive in reverse, be sure to follow all proper safety protocol.

Particularly on curves, the maximum posted speed limit may be safe to be driven in a car but too fast to be driven in a bus. Be especially careful when the road has been made slippery by rain or snow.

More students are killed each year during loading or unloading of school buses than while riding on school buses. Therefore, it is critical that school bus drivers follow appropriate safety procedures during loading and unloading. This process should never take place without being properly supervised.

Bus drivers should not engage in conversation with passengers, fuel a bus inside an enclosed building, or tow or push a disabled bus with riders aboard the vehicle. These are all considered to be prohibited practices.

When inspecting the interior of a bus, you must make sure everything is safe and in proper working condition. Take the time to ensure that each handhold and railing is securely in place and safe to be used.

The adjustment of mirrors should be checked prior to the start of any trip.

A school bus driver should always approach bus stops slowly and cautiously.

Properly adjusted crossover mirrors on a school bus should allow the driver to see the entire area in front of the bus, from the front bumper at ground level to a point where direct vision is possible. The mirrors should also display the right and left front tires touching the ground, as well as the area from the front of the bus to the service door.

The function of an Anti-Lock Braking System (ABS) is to prevent a vehicle's wheels from locking up when the driver brakes hard on a slippery surface.

On a bus designed to carry standing passengers, no passengers may stand in front of the rear of the driver's seat. Any such bus must have a line on the floor, or some other marking, that indicates where passengers may not stand. This is called a standee line.