Maryland MOTORCYCLE DMV Practice Test 15

Choose a helmet that meets U.S. Department of Transportation (DOT) and state standards. It should fit you snugly all the way around and be free of obvious defects.

In South Carolina, passengers under the age of 21 must wear a helmet and eye protection, though it is recommended that all motorcycle riders wear helmets and eye protection. Passengers should avoid wearing loose clothing that might catch on the motorcycle and should always lean with the operator when turning. Passengers should never be allowed to ride sidesaddle.

The brake light of a motorcycle is usually not as noticeable as the brake lights of a car. Flashing your brake light before slowing or stopping can help other drivers notice that you are about to brake.

Swerving is a quick maneuver that requires a lot of traction in order to be safely executed. Making sudden moves, such as swerving, on slippery surfaces should be avoided.

There is no single lane position that you always need to avoid. Adjust your position in response to changing conditions on the road.

Instead of or in addition to mechanical turn signals, operators may use hand signals to indicate turns or stops. If an operator's left arm is bent at the elbow and pointing upward, it means the operator plans to turn right or change lanes to the right.

An effective face shield should be free of scratches, be resistant to penetration, allow clear views to both sides, fasten securely, permit air to pass through, and provide enough space for eyeglasses or sunglasses to be worn underneath. It is important for a face shield to permit the passage of air because an airtight face shield can create fogging and make it difficult for a rider to see.

A staggered formation is generally the best way for a group to maintain close ranks while also allowing each rider to maintain an adequate cushion of space. A single-file formation is preferable when taking curves, turning, or entering or exiting a highway.

It is possible to brake while turning, but it should be done with great care. When a motorcycle is leaning to turn, there is less traction available for stopping because some of the traction is being used for turning.

The owner's manual should be your primary source of information about your specific type of motorcycle. Be sure to read the manual before operating your motorcycle for the first time.

You should use both brakes every time you slow down or stop. Always apply the brakes simultaneously.

When riding, you should securely tuck in the laces of your footwear so that they will not catch on your motorcycle.

No matter the speed, riders who are not wearing helmets are three times more likely to die from head injuries than riders who are wearing helmets at the time of a crash.

When being passed, motorcyclists should be careful not to be hit by any part of the passing vehicle, including its mirrors. In addition to the vehicle itself, motorcyclists should be aware of wind gusts coming from the passing vehicle and potential objects being thrown by a passenger in the vehicle who may not be paying attention to the road.

When riding on slippery surfaces, reduce your speed, brake using both brakes, and avoid sudden moves. Avoid the center of the lane and instead follow tire tracks left by cars. Always keep an eye out for hazards that may make a road surface especially slippery, such as oil spots and loose gravel.

Before setting off on any ride, you should do a thorough check of your motorcycle. Inspect the tires, oil and fluid levels, headlight, tail light, turn signals, brake light, clutch and throttle, mirrors, brakes, and horn.

Riding safely at night is challenging because it is harder to see and be seen than it is during the day. The absence of normal shadows and light contrasts makes it harder to judge distances.

A child passenger on a motorcycle should always ride immediately behind the operator. A child sitting in front may be unable to balance properly and could interfere with the operator's use of the controls.

The best way to handle a tailgater is to change lanes and let them pass you. Speeding up may cause them to tailgate you at a higher speed, only increasing the danger. Never ride on the shoulder of a road because drivers will never expect you to be there and may leave the road suddenly.

To turn, a motorcycle must lean. To make the motorcycle lean, press on the handgrip in the direction of the turn.

There are several strategies you can use to prevent someone from driving while under the influence of alcohol. You can arrange another way for them to get home, involve them in other activities to slow their pace of drinking, use any available excuse to stop them from leaving before they are sober, and get other friends involved to intervene as a group.

The best way to handle a tailgater is to change lanes and let them pass you. Speeding up may cause them to tailgate you at a higher speed, only increasing the danger.

To swerve, apply a small amount of pressure to the handgrip located on the side of your intended direction of escape. To swerve to the left, press the left handgrip, then press the right to recover. To swerve to the right, press the right handgrip, then the left.

In Maryland, anyone operating or riding a motorcycle must wear protective headgear that meets federal standards. A helmet is a rider's best protection against head or neck injury in the event of an accident.

Before riding, you should check the pressure and condition of your tires; check the oil and fluid levels; and make sure that the low beam headlight, high beam headlight, taillight, signal lights, and brake light all work properly.