Maine CAR DMV Practice Test 19

Solid yellow lines on two-lane roads indicate zones where passing is prohibited. If a solid yellow line appears next to a broken yellow line, drivers in the lane nearest to the solid yellow line may not pass. In some instances, both yellow lines will be solid, indicating that it is not safe to pass from either direction.

Lane markings and signs can tell you where it is unsafe to pass. Only you can tell if it is safe to pass in other areas.

Motorcycles are entitled to the width of a full lane. Be sure your vehicle is entirely in the left lane before attempting to pass a motorcycle on the left.

This sign indicates that U-turns are prohibited.

You must stop at a railroad crossing where signs, warning devices, or flaggers warn you of the presence of a train. It is illegal to drive around lowered gates.

To complete a turn safely, you should activate your turn signal three to four seconds before your turn.

If you are following another vehicle at a railroad crossing, check to make sure you have enough room to get all the way across before you drive onto the tracks. You should never try to pass another vehicle as you approach or cross a railroad crossing. Always check for trains before crossing any railroad tracks.

If you hear a siren or an air horn close by but do not know exactly where the emergency vehicle is, safely pull over to the right side of the road and stop until you are sure it is not headed toward you.

A solid red arrow in a traffic signal means the same thing as a circular red traffic light. When an arrow is red, traffic in the indicated lane must stop and may not turn in the direction that the arrow is pointing.

If two vehicles arrive at the same time to an intersection that has stop signs on all corners, the vehicle to the right has the right-of-way.

Pavement can become very slippery within the first 10 to 15 minutes of a rainstorm because the rain causes oil in the asphalt to rise to the surface of the road. This problem becomes even worse in hot weather. The heat combined with the water causes more oil to rise to the road surface.

To prevent hydroplaning, lower your speed in response to wet roads and keep your tires in good condition. If you detect a loss of control, take your foot off the gas, do not apply the brakes, maintain the direction of the vehicle, and allow the vehicle to slow to a manageable speed.

This sign warns that pavement is slippery when wet. In wet conditions, you should reduce your speed, avoid braking or changing direction suddenly, and increase the distance between your vehicle and the one ahead.

When approaching an intersection with a solid yellow traffic light, slow to a stop before entering the intersection, if it is safe to do so. If you can't stop safely, drive carefully through the intersection.

Pentagonal signs indicate that you are in or are approaching a school zone and/or school crossing. Be aware of children when driving near a school zone and follow posted speed limits.

To ensure that you will have time to react to hazards on the roadway, it is best to keep a cushion of space on all sides of your vehicle. Do not crowd vehicles to your left and right sides.

If a yellow panel with the message "Exit only" is on a highway sign, the lane below the sign will not continue through the interchange. Instead, the lane will go off of the roadway to form a ramp. If you are in a lane directly under an "Exit only" sign, you may change lanes to move through the interchange or you must exit the highway.

Warning signs are usually yellow with black markings. This sign indicates the presence of a crosswalk, regardless of if it is marked on the pavement or not. Upon seeing this sign, you should be alert and allow any pedestrians to cross the road safely.

Safe passing depends on cooperation between drivers. Don’t speed up when being passed. Don’t cut in too closely to a passed vehicle when re-entering a lane.

If your vehicle enters a skid, you should take your foot off of the brake and steer in the direction that you want to go. For example, if the rear of your vehicle is skidding to the left, you should steer to the left. This will help bring the front of the vehicle in line with the rear, thereby straightening out the vehicle's overall direction.

Because they are larger, trucks take longer to stop than cars traveling at the same speed. Other drivers should not pull in front of a truck and then slow down or stop.

A solid line along the side of the road indicates where its edge is, marking the boundary between the travel lane and the shoulder. If the edge line angles toward the center of the road, this means that the road is narrower ahead.

Do not pass where a train or another vehicle is likely to enter or cross the road. Passing is dangerous at intersections, crossroads, railroad crossings, and entrances to businesses. While passing, your view of potential pedestrians, cars, or trains is blocked by the car you are passing.

This sign indicate that the right lane ends ahead.

When leaving an alley, driveway, or parking lot to enter a roadway, you must stop before driving onto a sidewalk or sidewalk area. Pedestrians and existing traffic have the right-of-way.

A parking space marked by a "Reserved Parking for Persons with Disabilities" sign may only be used by vehicles that display Persons with Disabilities license plates, Disabled Veteran license plates, and/or disabled parking placards.

Develop a routine for entering and leaving your car. Before switching on the ignition, buckle your safety belt and see that all passengers do likewise.

A broken yellow centerline means that a driver may cross the centerline to pass another vehicle on the left as long as there is no oncoming traffic. Drivers should never cross a solid yellow centerline in order to pass.

Work zones are often stationary, but they may also be present in the form of moving vehicles striping lines, mowing, or removing snow. Work zones are marked by orange signs with black lettering or symbols. Slow down and pay extra attention when approaching or driving through a work zone.

An alert motorist can prevent accidents by slowing down and proceeding cautiously when approaching animals. It is against the law to purposefully frighten any animal being ridden, driven, or led on or near a public roadway.

Anything that causes you to take your attention away from driving, take your eyes off the road, and/or take your hands off the wheel is a distraction.

Highway markings provide information for drivers. Markings help drivers correctly position their vehicles on roadways, inform drivers of safe passing zones, and warn drivers about upcoming conditions.

Warning signs prepare drivers for upcoming road conditions and hazards and are usually yellow with black markings. This sign alerts drivers to potential traffic merging from the right. Drivers should prepare to allow the traffic to merge safely.

This sign warns that a steep downgrade is ahead on the road. Drivers should check their brakes.

Bicycles do not have turn signals so bicyclists use hand and arm signals to alert other drivers to their intentions. If a bicyclist puts their left arm straight out, they are signaling that they intend to turn left.

You must yield the right-of-way to all emergency vehicles using a siren, air horn, and/or flashing red, blue, or white lights. Where possible, you must pull over to the right edge of the road. If you are in an intersection, drive through the intersection before you pull over.

This sign indicates that a steep downhill grade is ahead.

When a school bus is flashing its red lights and has its stop arm extended, motorists must come to a full stop until the lights are turned off, the stop arm is withdrawn, and the bus begins moving again.

Alcohol and other drugs can negatively effect a number of skills needed for safe driving, including a driver's reaction time, coordination, alertness, and ability to concentrate.

When stopping your vehicle on the roadway, first check your mirrors for traffic. Be aware of surrounding drivers as you release the accelerator and allow your vehicle to slow. Move your foot to the brake pedal and press with steady pressure for a smooth stop.