Kansas MOTORCYCLE DMV Practice Test 6

The mirrors of motorcycles have blind spots, just like those of cars. Always turn your head to check your blind spot before changing lanes.

Traction may be poor on surfaces such as wet, snowy, icy, or muddy pavement; gravel roads; lane markings; and steel plates and utility hole covers.

Your feet should remain on your footrests while riding to help you maintain proper balance.

When riding at night, reduce your speed and increase your following distance. Visibility is lowered at night and you will need the additional time and space to react to upcoming hazards.

Maintaining a cushion of space around your motorcycle at all times helps ensure that you will have time to react and space to maneuver if someone else on the road makes a mistake.

The greatest potential for conflict between you and other traffic exists at intersections.

If a hazard requires you to brake and swerve, you should take these actions separately. Never brake while swerving because doing so can cause your motorcycle to fall over.

In most cases, it is safest to ride straight within your lane to cross angled railroad or trolley tracks. Changing the angle of your path to cross tracks may send you into another lane, causing a collision with oncoming traffic.

When approaching a blind intersection, move into the lane position that makes you the most visible to surrounding drivers.

The front brake of a motorcycle is more powerful that the rear brake and can provide at least 70 percent of the bike's total stopping power.

Because it can be difficult to judge distances in the dark, ride with a following distance of at least three seconds when traveling at night.

Georgia law requires a rider to wear eye protection when on a moving motorcycle. A full face shield provides a rider with the best possible protection.

Wear brightly-colored clothing to maximize your visibility when riding, even during the daytime. Clothing made with reflective materials can also be helpful.

On a two-lane road, a group of motorcyclists should pass another vehicle one at a time. Each motorcyclist should complete the pass before another begins to pass.

There is no single lane position that is always best and no single lane position that should always be avoided. Adjust your lane position as circumstances warrant.

Before setting out on a ride, you should make sure that your motorcycle's fuel supply valve is open. If the fuel valve is closed, the engine may still start with the fuel that is remaining in the lines from a previous ride, but it will stall once the lines are empty.

Ask your passenger to wait to mount the motorcycle until after you have started the engine. They should sit as far forward as possible without crowding you and firmly hold onto your waist, hips, or belt.

All riders and passengers are required to wear a helmet when riding a motorcycle, motor-driven cycle, or motorized bicycle.

When turning, you should always lean in the direction of the turn. Slow down before entering the turn.

All passes must be completed within the posted speed limits and only in areas where passing is permitted.

On a slippery surface, any sudden change in speed or direction could result in a skid. Be as smooth as possible when you speed up, shift gears, turn, or brake on such a surface.

If steering suddenly feels heavy, it is possible that your front tire has gone flat. Stop riding and check your tires as soon as possible.

The best way to deal with a tailgater is to allow them to pass you. Speeding up may only result in them continuing to tailgate you at the higher speed, which is even more dangerous.

Saddlebags should be loaded with approximately equal weights. If a load is distributed unevenly between bags, it may cause the motorcycle to drift to one side.

When being passed on your left, you should ride in the center portion of your lane. Riding in the right portion of the lane can be dangerous as it may tempt the passing driver to re-enter your lane too quickly.