Over 95% pass rate when practice at DMV Practice Test

Kansascarpractice test 21

Kansas CAR DMV Practice Test 21

Take 24 practice tests for CAR is the best way to prepare for your Kansas DMV exam is by taking our free practice tests. The following question are from real Kansas DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.

Number of Test
24
Number of Question
25
Passing score
20
13%
  • 0Correct
  • 0Incorrect
Not enough to pass :-(

Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.

Test againNext up practice
1. If your wheels drop off the roadway or pavement edge, you should:
Wait until it is safe to do so, then gradually re-enter the roadway.
Turn back onto the roadway immediately.
Stop.

If your wheels drop off the roadway or pavement edge, do not attempt to turn back onto the roadway immediately. Instead, reduce your speed, check traffic, and gradually turn back onto the roadway when it is safe to do so.

2. When driving in fog, rain, or snow, use:
Low beams.
High beams.
Fog lights only.

Low beam headlights should be used in fog, rain, and snow. The light from high beams will reflect back to the driver under these weather conditions, causing a glare that will make it difficult to see ahead.

3. If you have trouble seeing other vehicles because of dust or smoke blowing across the roadway, you should drive more slowly and turn on your:
Emergency flashers.
Parking lights.
Headlights.

You must turn on your headlights any time conditions prevent you from seeing other vehicles. Other drivers may have trouble seeing you, too.

4. If a child is about to run into the street, you should:
Start to prepare to slow down.
Flash your headlights.
Sound a sharp blast of your horn.

If there is danger, you may need to sound a sharp blast on your horn. Do this when a child or any other pedestrian is about to enter into the street in front of your moving vehicle.

5. Signs with orange backgrounds are:
/data/image/dmv_image/car/illinois-construction.png
General warning signs.
Construction and maintenance warning signs.
Regulatory signs.

The color orange is used only for construction and maintenance warning signs.

6. This sign means:
/data/image/dmv_image/car/california-two_way_traffic.png
Four-lane traffic ahead.
Divided highway ahead.
Two-way traffic ahead.

Warning signs are usually yellow with black markings. They alert you to conditions that are immediately ahead. This sign warns that you are leaving a separated one-way highway and will soon be driving on a two-way highway.

7. You are driving on a one-way street. You may only turn left onto another one-way street if:
You increase your speed before the turn.
Traffic on the street moves to the right.
Traffic on the street moves to the left.

You may turn left onto a one-way street that moves to the left if there is no sign prohibiting the turn. You may not turn left onto a one-way street where traffic moves to the right.

8. When you see a flashing yellow light at an intersection, you should:
Yield to all traffic before crossing the intersection.
Stop, then enter the intersection when it is safe to do so.
Slow down and cross the intersection carefully.

A flashing yellow light at an intersection indicates that drivers should slow to a safe and reasonable speed and proceed with caution.

9. If oncoming headlights are blinding you while you are driving at night, you should:
Look toward the right edge of the road.
Switch your lights to high beams.
Turn your lights on and off.

If the headlights of an oncoming vehicle are blinding, glance toward the right edge of the road instead of looking directly ahead. This should keep your vehicle safely on the road until you pass the oncoming vehicle.

10. This sign means:
/data/image/dmv_image/car/illinois-side_road.png
Side road.
Merge.
Yield the right-of-way.

This sign indicates that there is an intersection with a side road ahead.

11. This sign means:
/data/image/dmv_image/car/illinois-slippery_pavement.png
Slippery when wet.
Stop sign ahead.
No U-turn.

All roads are slippery and dangerous when wet. This sign warns of conditions that can cause a driver to lose control of a car. A driver should slow down when coming upon wet pavement because it takes longer to stop.

12. A vehicle suddenly cuts in front of you, creating a hazard. What should you do first?
Honk and step on the brake firmly.
Take your foot off the gas pedal.
Swerve into the lane next to you.

If a vehicle merges in front of you too closely, take your foot off of the accelerator. This will create space between you and the vehicle ahead without requiring you to slam on your brakes or swerve into another lane.

13. This sign means:
/data/image/dmv_image/car/tennessee-slippery_when_wet.png
Slow down; curving road ahead.
Slow down and do not use your brakes.
Slow down; slippery when wet.

This sign warns that the road ahead becomes slippery when wet.

14. An instructional permit allows you to:
Operate a motor vehicle while supervised by a driver who is over the age of 21.
Operate a motor vehicle without supervision.
Observe another driver who is operating a motor vehicle.

Holding an instructional permit allows you to drive only when a licensed adult is accompanying you in the front seat. The licensed adult must be at least 21 years old and have at least one year of driving experience.

15. A pentagon-shaped sign is a:
/data/image/dmv_image/car/illinois-school_2.png
Stop sign.
Regulatory sign.
School zone or school crossing sign.

A five-sided sign is used to alert drivers to a school zone. Some pentagonal signs specifically indicate crosswalks within school zones where children or other pedestrians may be present.

16. This white sign means you should not pass other vehicles:
/data/image/dmv_image/car/california-do_not_pass.png
Until after you pass the sign.
Unless it seems safe to do so.
For any reason.

A white rectangular sign indicates that you must obey the stated rule. This sign means that drivers should not pass other vehicles for any reason.

17. Which of the following statements about blind spots is true?
Blind spots are eliminated if you have one outside mirror.
Large trucks have bigger blind spots than most passenger vehicles.
Blind spots can be checked by looking in your rearview mirror.

Even if a vehicle is properly equipped with rearview and outside mirrors, it still has blind spots that cannot be seen in the mirrors. Large trucks have much larger blind spots than most passenger vehicles.

18. This white sign means:
/data/image/dmv_image/car/alabama-railroad_crossing.png
The railroad crossing is controlled. Continue at your regular speed.
Look, listen, and prepare to stop at the crossing if necessary.
Stop at the railroad tracks and wait for a signal before crossing.

When approaching a railroad crossing, you must look, listen, slow down, and prepare to stop. Let any trains pass before you proceed.

19. When passing a row of parked vehicles, you should:
Be prepared for a person or vehicle to unexpectedly enter your lane.
Expect all other drivers and pedestrians to respect your right-of-way.
Drive closely to the parked vehicles to allow more room for moving traffic.

Keep a space between your vehicle and parked vehicles. A person may step out of a parked vehicle or out from between the parked vehicles without looking. A driver may begin moving their vehicle before realizing you are there.

20. Which of these is a safe driving technique?
Using your high beam lights in the fog.
Staring at the road ahead of your vehicle.
Checking your rearview mirrors frequently.

To stay aware of hazards, you should scan the road and check your rearview mirrors every two to five seconds. Constantly staring at just the road ahead of you is dangerous. If you must drive in foggy conditions, you should use your low beam headlights, not your high beam headlights.

21. Which of the following statements about blind spots is true?
They are eliminated if you have one outside mirror on each side of the vehicle.
Large trucks have bigger blind spots than most passenger vehicles.
Blind spots can be checked by looking in your rearview mirrors.

Blind spots are areas that a driver cannot see if they look in their mirrors. Large trucks have large blind spots that drivers of other vehicles should avoid.

22. What does this road sign indicate?
/data/image/dmv_image/car/arkansas-school_zone.png
Directions for children
School zone ahead
Playground area ahead

Pentagonal signs indicate that you are in or are approaching a school zone and/or school crossing. Be aware of children when driving near a school zone and follow posted speed limits.

23. Check your rearview mirrors:
Often to see how traffic is moving behind you.
To see if a vehicle is in your blind spot.
Only when you are slowing down.

When driving, do not develop a fixed stare. Frequently check your rearview mirrors so you know the positions of vehicles near you.

24. You are approaching an intersection at the posted speed limit when the signal turns yellow. You should:
Slow down and proceed through the intersection without caution.
Speed up to cross the intersection before the light turns red.
Stop before entering the intersection, if you can do so safely.

A solid yellow light means "caution" and signals that the light will soon turn red. You should stop at a solid yellow light if you can do so safely; otherwise, you should cautiously cross the intersection.

25. A U-turn is not permitted:
In a parking lot.
On or near any curve or hill.
On a straight roadway with a clear view for 500 feet in both directions.

You must never turn around while on or near any curve or hill. You may not be able to see oncoming traffic or pedestrians and may cause a collision.

Try more CAR Kansas Practice Test

Your Progress
  • 0Incorrect (5 allowed to pass)
  • 0Correct
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25