Indiana MOTORCYCLE DMV Practice Test 7

When riding in a group, riders should maintain close ranks while also allowing adequate space cushions around each rider. Staying close together makes the group easier to see and reduces the risk that riders will become separated. Riders should not pair up because doing so does not allow adequate room for them to maneuver.

Blind spots, by definition, are areas that you cannot see by just looking in your mirrors. Turn your head to the side and check over your shoulder for vehicles in your blind spot before you change lanes.

An expanded cushion of space is needed if your motorcycle will take longer than normal to stop. If the pavement is slippery, if you cannot see through the vehicle ahead of you, or if traffic is heavy and another driver may try to squeeze in front of you, open up to a larger following distance.

All motorcycles are slightly different, so you should check the controls and make sure you know the gear pattern before riding an unfamiliar motorcycle. Work the throttle, clutch, and brakes a few times prior to riding.

A properly chosen lane position can optimize a number of safety factors. Your lane position should keep you out of other vehicles’ blind spots, increase your ability to see and be seen, help you avoid surface hazards, help you avoid wind blasts from other vehicles, and provide you with an escape route from any hazards that might arise. You should be positioned in a way that discourages other drivers from trying to share your lane.

For your protection, you should always wear a long-sleeved jacket when riding, even in warm weather when you may not think you need a jacket. It can help protect you against the sun and dehydration in hot weather.

An integrated braking system is a variant of a linked braking system. Partial front braking is applied whenever the rear brake is activated. Check your owner's manual for a detailed explanation of the braking system on your motorcycle.

Always be flexible about your lane position, especially when riding at night. Be especially careful to employ safe riding strategies when riding under conditions that are less than ideal.

Swerving is a quick maneuver that requires a lot of traction in order to be safely executed. Making sudden moves, such as swerving, on slippery surfaces should be avoided.

Shift down through the gears with the clutch as you slow or stop. Remain in first gear while you are stopped so you can move quickly if needed.

Always simultaneously use both brakes to stop. The brakes are most effective when used at the same time.

Goggles can protect your eyes, but only a face shield can protect your entire face in a crash.

To protect yourself against injury, you should wear a DOT-compliant helmet; face or eye protection; a jacket and long pants made of sturdy material; boots or shoes that are high and sturdy enough to cover and support your ankles; and gloves made of durable material.

Oily drippings from cars collect in a strip in the center of each lane. Unless the road is wet, this area still generally offers enough traction for motorcyclists to safely ride. You should still avoid riding on big buildups of oil and grease, often found at busy intersections or near toll booths.

Secured loads should be low. Putting them too high up, such as on a sissy bar, can raise the motorcycle's center of gravity and upset its balance. Loads should be as evenly distributed as possible on each side of the motorcycle to avoid pulling the bike to one side.

A number of surfaces can provide poor traction for tires. Wet pavement; roads covered in loose gravel or sand; muddy, snowy, or icy areas; painted lane markings; oily areas; and metal covers and plates in the road can be more hazardous for a motorcyclist than dry pavement.

There are several advantages to keeping groups of riders small. In comparison to a large group, a small group is easier for other vehicles to pass safely, is less likely to get separated by traffic or stop lights, and creates less need for slower riders to hurry to catch up to the rest of the group.

Riding in cold weather for long periods of time can cause severe chill, fatigue, and even hypothermia. Be sure to wear proper clothing to protect you from the elements.

When riding at night, travel at a slower speed than you would during the day under similar weather and traffic conditions. It can be difficult to see potential hazards in the dark, so slowing down can increase your chances of avoiding any hazards.

Signs informing road users of road regulations, such as speed limits, are normally rectangular and colored white with black lettering or symbols. Riders must follow the rules posted on these regulatory signs.

Leather jackets and pants provide the greatest level of protection when riding.

Oily drippings from cars and trucks build up in the center of each lane. Unless the road is wet, this strip usually still provides enough traction more a motorcycle to operate safely. The strip is generally narrow enough that you can ride to either side of it and still be in the center portion of the lane.

When riding, you should securely tuck in the laces of your footwear so that they will not catch on your motorcycle.

Rounded, or convex, mirrors provide a wider view of the road than flat mirrors, but they also make objects seem farther away than they actually are.

A plastic, shatter-resistant face shield helps protect your entire face, including your eyes. Goggles can protect your eyes, but not the rest of your face. A windshield is not an adequate substitute for either.