Indiana MOTORCYCLE DMV Practice Test 10

Oily drippings from cars collect in a strip in the center of a traffic lane. Unless the road is wet, this area will generally still provide enough traction for motorcyclists to ride safely. Because the strip is usually no more than two feet wide, it is often possible to ride to one side of the strip and still be in the center portion of the lane.

The gearshift lever of a motorcycle is located in front of the left footrest and is operated by the rider's left foot.

In potential high-risk areas, such as school zones or construction zones, cover the clutch and both brakes. This cuts down the amount of time you will need to react to a hazard.

To regain control of a locked rear wheel, the brake must be released. However, if you accidentally lock the rear brake on a good traction surface, you can keep it locked until you have completely stopped.

A riding jacket and long pants should still be worn when riding in hot weather. In addition to their other safety benefits, they can protect a rider from heat exhaustion and dehydration.

A helmet should meet U.S. Department of Transportation (DOT) and state standards and fit snugly all the way around to provide maximum protection. It should be free of defects such as cracks, loose padding, or frayed straps.

Strategies for making yourself more visible include wearing brightly-colored and reflective clothing, keeping your headlight on at all times, and varying your lane position as conditions demand.

You should wear gear that helps protect you while you ride. It is best to wear a DOT-approved helmet, face or eye protection, and protective clothing.

Because of the extra weight placed on a motorcycle by a passenger, you may need to adjust the motorcycle's shocks before carrying a passenger. Because the motorcycle will sit at a different angle, you should also adjust the headlight and mirrors to compensate for the additional weight.

In potential high-risk areas, such as near intersections, shopping areas, school zones, and construction zones, cover the clutch and both brakes to reduce the time you will need to react to potential hazards.

The gearshift lever is located in front of the left footrest and is operated with the left foot.

Because road and traffic conditions are always changing, the safest lane position is also always changing. Choose the position that will maximize your space cushion and allow other drivers to see you most easily.

Secured loads should be low. Putting them too high up, such as on a sissy bar, can raise the motorcycle's center of gravity and upset its balance. Loads should be as evenly distributed as possible on each side of the motorcycle to avoid pulling the bike to one side.

Any time a driver may be tempted to try to squeeze into your lane next to you, ride in the center portion of the lane to discourage them from doing so.

Instead of or in addition to mechanical turn signals, operators may use hand signals to indicate turns or stops. If an operator's left arm is bent at the elbow and pointing downward, it means the operator plans to slow down or stop.

The surest way to avoid the risks of riding under the influence of alcohol is to not ride after you have been drinking. Any amount of alcohol can impair your abilities.

To increase your visibility, you can wear clothing that is brightly-colored or that contains reflective materials. Adding auxiliary lights to your motorcycle, using your turn signals, and flashing your brake light when appropriate are also good ways to get the attention of other road users.

When approaching railroad tracks that cross your lane at an angle, it is best to simply cross the tracks while riding straight within your lane. Turning to cross the tracks at a 90-degree angle could be dangerous because you could end up crossing into another lane of traffic.

Riding directly next to another vehicle is dangerous because you could be riding in the vehicle's blind spot. Additionally, the vehicle may block your route of escape if another hazard arises. If you find yourself riding directly alongside another vehicle, either speed up or drop back.

Passengers should get on a motorcycle only after the engine has been started and the transmission is put in neutral. They should sit as far forward as possible without hindering the operator's control of the motorcycle and should hold onto the operator's waist, hips, or belt.

When being passed, it is generally a good idea to ride in the center portion of your lane. Being on the side nearest the passing vehicle increases your risk of a collision. Being on the side farthest from the passing vehicle may prompt the other driver to merge back into your lane before it is safe.

The best way to handle a tailgater is to change lanes and let them pass you. Speeding up may cause them to tailgate you at a higher speed, only increasing the danger. Never ride on the shoulder of a road because drivers will never expect you to be there and may leave the road suddenly.

In warm weather, a riding jacket will help prevent dehydration in addition to serving the basic protective function that it provides at all times. Many jackets are designed to protect riders against overheating, even in warm weather.

To stop quickly, apply both brakes at the same time.

Hand signals are an important part of communication when riding in groups. A lead rider raising their left arm and extending their index finger means that the group of riders should move into a single-file formation.