Hawaii MOTORCYCLE DMV Practice Test 11

When making a turn, you should look through the turn to where you want to go. Turn just your head, not your shoulders, and keep your eyes level with the horizon.

Some motorcycles are equipped with an Anti-Lock Braking System (ABS). ABS is designed to prevent skidding and wheel lock-up when motorcyclists are stopping in straight-line, panic situations. ABS operates when maximum pressure is applied to both the front and rear brake controls. If electronic sensors detect the possibility of a wheel lock, brake hydraulic pressure is released then re-applied to maintain maximum braking effectiveness.

Drippings from cars tend to form an oily strip in the center of each lane. Unless conditions are wet, it is usually still safe for a motorcycle to operate on the center strip.

To maintain proper balance, your feet should be placed firmly on the footrests and not dragged on the ground. Do not point your toes downward, as this may cause them to catch on the road. Keep your feet near the controls so you can reach them quickly, if needed.

A plastic, impact-resistant face shield provides the greatest degree of protection for a wearer's eyes and face. Eyeglasses or sunglasses are not an adequate substitute. In Vermont, you are not legally required to wear eye or face protection if your motorcycle has a windshield, though it is recommended.

On average, a person's body can eliminate the alcohol content of about one drink per hour. However, it is still possible for alcohol to accumulate in a person's system even if they consume only one drink per hour. This accumulation can still affect their ability to ride safely.

Your first and best protection against collisions with other vehicles is simply to keep your distance from them. The only way to be sure you will have enough time to react to mistakes made by other drivers is to leave plenty of space between you and the vehicles around you. Wearing proper gear is also important when riding a motorcycle.

A motorcycle requires more frequent attention than a car. Make a complete check of your motorcycle before every ride.

Motorcycle headlights are generally smaller and less powerful than those of cars.

A rider should always use both brakes every time they slow or stop.

While the basic techniques for safely passing and being passed are the same as when driving a car, visibility is more critical when riding a motorcycle. The smaller size of a motorcycle makes it easier for you to disappear into another vehicle's blind spot, or for the driver to fail to notice you even if they are able to see you.

Heavier items should be loaded in front of the tank bag. You should try to place the load over or in front of the rear axle. Putting the load behind the rear axle may affect your control.

After mounting your motorcycle, you should make sure the clutch, throttle, horn, and brakes all work properly. Clean and adjust the mirrors and make sure that the fuel supply valve is open.

When riding, always look well ahead of your vehicle to help you anticipate potential hazards. Doing this will help you react to hazards before meeting them.

Most wobbles are caused by improper loading of the motorcycle, unsuitable accessories, or incorrect tire pressure.

Most motorcycle crashes happen on trips that are shorter than five miles in length at speeds slower than 30 mph.

Most crashes happen on trips that are shorter than five miles, just a few minutes after the rider starts out.

When riding behind a passenger vehicle, it is usually best to ride in the center of the lane so you will be visible in the driver's rearview mirror. Most drivers check their rearview mirrors much more often than their side mirrors, so this lane position will increase your chances of being seen.

Always simultaneously use both brakes to stop. The brakes are most effective when used at the same time.

Before every ride, you should complete a thorough check of your motorcycle. Be sure to check the rims and spokes to make sure none are bent, loose, or damaged; the condition and tread of the tires; and all of the lights.

If either of your tires go flat and you must brake, gradually apply the brake of the tire that is not flat (if you are certain of which tire that is).

Inexperienced riders should ride near the front of a group, just behind the leader, so more experienced riders can keep an eye on them from behind.

To reduce the risk of fatigue on a long trip, dress to protect yourself against heat, rain, wind, or snow. Limit yourself to no more than about six hours of riding per day, and stop to rest at least once every two hours. Avoid consuming artificial stimulants, as you may experience extreme fatigue when they begin to wear off.

Avoid riding directly alongside another vehicle, since this may place you in the vehicle's blind spot. If the driver can't see you, they may enter your lane without warning. Riding alongside a vehicle is also dangerous because the vehicle will block your route of escape if a hazard arises.

Long-term exposure to wind noise while riding can cause hearing damage, even if you wear a helmet. Use of proper hearing protection is recommended to prevent damage.