Florida CDL DMV Endorsement Passenger 1

During the basic vehicle control skills test, a pull-up will be scored any time an applicant stops and pulls forward to gain a better position. Stopping without changing direction will not. An excessive number of pull-ups will count as errors.

Rust around wheel nuts may mean that they are loose. Check the tightness of the nuts if you see any rust in the area.

When stopping a bus at a railroad crossing, you should open your forward door if doing so will improve your ability to see or hear an approaching train.

You should finish each exercise with your vehicle in the exact position described by the examiner. You can be penalized for failing to complete an exercise exactly in the manner described by the examiner, potentially resulting in failure of the basic control skills test.

While taking the on-road driving skills test, check for traffic and use your mirrors regularly, especially when encountering intersections. Scan and check for pedestrians in areas where they may be present.

To reduce the chances of driving distracted, you should avoid eating, drinking, or smoking while driving. Anything that diverts attention from the task of driving is a distraction.

Bridges usually freeze before the rest of the road. You should be especially careful when crossing bridges if the temperature is near the freezing point.

A passive railroad crossing is a crossing that lacks control devices, like gates or warning lights. Before crossing a passive railroad crossing, you should search the tracks for approaching trains coming from either direction.

Buses must never carry labeled radioactive materials in the area occupied by passengers.

A bus should not be refueled while passengers are on board unless it is absolutely necessary. In particular, a bus with passengers on board should never be refueled inside an enclosed building.

To ensure that your vehicle does not roll backward when beginning to move after a stop, you should partly engage the clutch before removing your right foot from the brake pedal.

When checking the springs as part of the vehicle inspection test, you should look for missing, shifted, cracked, or broken leaf springs, as well as broken or distorted coil springs. If the vehicle is equipped with torsion bars, torque arms, or other types of suspension components, ensure that they are not damaged and are mounted securely.

On a bus, all baggage and freight must be stored in a manner that allows the driver to move freely and easily; allows riders to exit by any window or door in the event of an emergency; and protects riders from injury if the items fall or shift.

While a bus is traveling, passengers may not stand any farther forward than the rear of the driver's seat. To mark this barrier, a bus that is designed to allow passengers to stand must have a two-inch line on the floor (or some other means of showing passengers where they cannot stand). This is known as the standee line.

In extremely hot weather, tire pressure can increase to dangerous levels due to the expansion of the air in heat. To keep an engine from overheating, it is important that there be enough oil and coolant in the engine compartment.

A broken exhaust system can allow poisonous fumes to enter a vehicle's cab or sleeper berth. Be sure to regularly check your exhaust system for defects.

During the on-road driving test, you must not stop, change gears, pass another vehicle, or change lanes while any part of your vehicle is in a railroad crossing.

The first step of a vehicle inspection is to review the last vehicle inspection report. Only sign the report if noted defects are certified to have been repaired.

When approaching your vehicle before an inspection, make note of its general condition and ensure that it is not damaged or leaning. Look under the vehicle for fresh leaks. Check around the vehicle for hazards to movement, such as people, other vehicles, or low-hanging wires or tree limbs.

It is best to avoid driving through large puddles or moving water. If there is no way to avoid driving through water, you should slow down, shift into a low gear, and gently apply the brakes. Pressing linings against the brake drums or discs will keep water, mud, silt, and sand from getting inside the brake mechanisms.