Colorado MOTORCYCLE DMV Practice Test 10

To discourage automobile drivers from trying to share your lane, ride in the center portion of the lane.

Oily drippings from cars and trucks build up in the center of each lane. Unless the road is wet, this strip usually still provides enough traction more a motorcycle to operate safely. The strip is generally narrow enough that you can ride to either side of it and still be in the center portion of the lane.

There is no single lane position that is always best and no single lane position that should always be avoided. Vary your lane position based on changing road and traffic conditions.

Before setting off on any ride, you should do a thorough check of your motorcycle. Inspect the tires, oil and fluid levels, headlight, tail light, turn signals, brake light, clutch and throttle, mirrors, brakes, and horn.

When approaching a blind intersection that is controlled by a stop line or stop sign, you must first stop where indicated. You may then edge forward and stop again just short of where the cross traffic lane meets your lane. From that position, lean your body forward and look around buildings, parked cars, or bushes to see if anything is approaching. Make sure your front wheel stays out of the crossroad while you are looking.

It is possible to use both brakes while turning, but it must be done with great care. Some of the tires' usual traction is being used to make the turn while the motorcycle is leaning, so less traction is available for stopping.

When riding, sit so that you can use your arms to control the motorcycle rather than to hold yourself up. Your arms should be slightly bent when you hold the handgrips. To help maintain your balance, keep your knees against the gas tank and your feet firmly on the footrests.

Riding next to parked cars presents a number of potential dangers. A driver might pull out of parking space and into your path without looking. Car doors may be opened into your lane and pedestrians may step out from between cars.

If you cannot avoid hitting an obstacle in the roadway, you should try to hit it at as close to a 90-degree angle as possible. Slow down as much as you can before contact, keep your motorcycle upright, rise slightly off of your seat, and roll the throttle slightly to lighten the front end just before impact.

When riding on slippery surfaces, you should use both brakes to slow down. Squeeze the brake lever gradually to avoid locking the front wheel and use gentle pressure on the rear brake.

When you are stopped at an intersection, use your mirrors to check for cars approaching you from behind. The drivers may not notice you until they are too close and you may need to react.

Choose riding boots or shoes that are high and sturdy enough to cover and support your ankles. Choose footwear with soles made of hard, durable, slip-resistant material.

When riding behind a passenger vehicle, it is usually best to ride in the center of the lane so you will be visible in the driver's rearview mirror. Most drivers check their rearview mirrors much more often than their side mirrors, so this lane position will increase your chances of being seen.

It is possible to brake while turning, but it should be done with great care. When a motorcycle is leaning to turn, there is less traction available for stopping because some of the traction is being used for turning.

A small technical fault can have much more serious consequences on a motorcycle than on a car. To avoid these consequences, inspect your motorcycle before every ride.

To increase your chances of being seen, wear brightly-colored clothing, use your headlight at all times, and use your turn signals.

Successful motorcyclists know that they are safest when they are clearly seen by other road users. Use your headlight, brake light, signals, and lane position to maximize your visibility.

The minimum number of drinks remaining in a person's system can be estimated by subtracting the number of hours since their last drink from the total number of drinks consumed. For example: a person who has consumed seven drinks in three hours would have a minimum of four drinks remaining in their system three hours later.

When riding on a slippery surface, it is safest to decrease your speed. Making sudden moves on a slippery surface could cause your motorcycle to skid. Do not travel on the shoulder to escape a slippery road.

Motorcycles have blind spots, just like any other vehicle. You should always turn your head to check for traffic in your blind spot before changing lanes. Do not rely on your mirrors alone.

Alcohol is a depressant. It slows down and impairs bodily functions, both physical and mental.

Exposure to engine and wind noise can damage your hearing, even if you are wearing a helmet. Hearing protection can guard against this while still allowing you to hear essential sounds like horns and sirens.

While a staggered group formation is usually best, it is better to switch to a single-file formation when turning, taking curves, or entering or exiting a highway.

Riding directly alongside another vehicle is dangerous because it may place you in the driver's blind spot. Additionally, the vehicle will block your path of escape.

A motorcycle may weave while riding over rain grooves or bridge gratings, but this is generally not dangerous. If your motorcycle begins to weave, simply relax and proceed straight ahead at a steady speed. Trying to ride in a zigzag pattern to compensate for the weave will only increase the hazard.