Arkansas CAR DMV Practice Test 24

Pennant-shaped yellow signs like this are used to indicate a no passing zone.

Before changing lanes, you should check your side mirrors and look over your shoulder to make sure it is safe to proceed.

Before you enter an intersection, look to both the left and right for approaching vehicles or crossing pedestrians. Look to your left a second time, as vehicle approaching from your left will be closer than those approaching from your right. Look across the intersection before you start to move to make sure the path is clear all the way through.

Warning signs are usually yellow with black markings. This sign indicates that a divided highway is beginning and cars should keep to the right.

Being too close to an airbag as it inflates can be dangerous. Placing yourself 10 inches from your airbag provides you with a cushion of safety, should there be a collision. This distance is measured from the center of the steering wheel to your breastbone.

A broken yellow centerline means that a driver may cross the centerline to pass another vehicle on the left as long as there is no oncoming traffic. Drivers should never cross a solid yellow centerline in order to pass.

Because large trucks require more time to accelerate than smaller vehicles, trucks can lose speed driving up long or steep hills. Be cautious when driving behind a large truck and be sure to give the vehicle additional space, especially when driving on an incline.

Hydroplaning is caused by driving too fast on a wet road. Slow down when driving on wet pavement to prevent hydroplaning.

This sign warns of two-way traffic.

Alcohol is a depressant that dulls your judgment and makes your reflexes unreliable.

Yellow lane markings indicate a separation of lanes where traffic is traveling in opposite directions. When you see double solid yellow lane markings, passing is prohibited from both directions.

This sign warns of a dangerous downgrade or hill ahead. The hill may be very long or steep, or it may have sharp curves.

When a line separating lanes of traffic is dashed, drivers may cross the line to pass or change lanes. White lines separate lanes of traffic moving in the same direction.

When approaching a railroad crossing, you must look, listen, slow down, and prepare to stop. Let any trains pass before you proceed.

All roads are slippery and dangerous when wet. This sign warns of conditions that can cause a driver to lose control of a car. A driver should slow down when coming upon wet pavement because it takes longer to stop.

Watch for any pedestrian who may cross your path. If you see pedestrians near the road where you are driving, slow down and be prepared to stop, if necessary.

To avoid being blinded when driving at night, do not look directly at the headlights of oncoming cars. Instead, look toward the right edge of the road until the oncoming driver has passed.

Rumble strips create noise and vibrations to warn drowsy or inattentive drivers that they are straying off of the road or are approaching a stop sign or signal.

Reduce your speed and be prepared to slow down or stop for highway equipment. Driving carefully through work zones improves safety for drivers, pedestrians, bicyclists, and road workers.

If you are approaching a railroad crossing that has no safety barrier, cross the tracks only after checking in both directions for any oncoming trains. If a train is approaching, come to a complete stop at a safe distance and wait for the train to pass. Never try to outdrive a train.

A double yellow centerline means that it is prohibited for traffic from either direction to cross the centerline to pass.

The speed at which you should drive your vehicle depends on road conditions, the weather, and the legal speed limit. You may never drive above the legal speed limit. Decrease your speed when anything makes conditions less than ideal.

Treat a flashing red traffic signal the same as you would treat a stop sign. Come to a complete stop, yield to oncoming traffic or pedestrians, and proceed when the way is clear.

An octagonal sign always means stop. When approaching a stop sign, you must come to a complete stop at the marked stop line and proceed only when it is safe to do so. If there is no stop line, stop before the crosswalk. If there is no crosswalk, stop before the intersection at a point from which you can see oncoming traffic.

You should drive more slowly at night than during the day because it is not possible to see as far ahead at night. You should make sure that you can stop within the area illuminated by your headlights.