Arizona CDL DMV Endorsement Bus 2

During the on-road driving test, do not stop, change gears, pass another vehicle, or change lanes while any part of your vehicle is in a railroad crossing.

When exiting your vehicle during the basic vehicle control skills test, you must face the vehicle and maintain three points of contact at all times. If your testing vehicle is a bus, you must maintain contact with the handrail. Exiting the vehicle incorrectly may result in automatic failure of the basic control skills test.

The process of loading or unloading students from a school bus requires a driver's full concentration. If there is a behavioral issue on the bus, wait until the exiting students are safely off the bus and out of the way before you address the problem on the bus.

After students unload at school, a school bus driver should walk through the bus to check for sleeping students, hiding students, and items that students may have left behind. Students should exit the bus in an orderly fashion with the driver supervising.

If a student tries to retrieve a dropped object, they may disappear from the driver's line of sight. This is potentially very dangerous. Rather than retrieve dropped items themselves, students should move to a point of safety outside of the bus's danger zones, get the driver's attention, and wait for the driver to retrieve what has been dropped.

A school bus's long sides are vulnerable to being pushed by winds. If you must drive in windy conditions, you should maintain a strong grip on the steering wheel, try to anticipate wind gusts, and slow down. If necessary, contact your dispatcher for instructions on how to proceed.

School bus drivers may only pick up students at official stops designated by authorized school officials.

When asked to make a turn during the on-road driving test, you must check traffic in all directions and use your turn signal.

On a school bus, the overhead inside rearview mirror is used to monitor passenger activity inside the bus. It should be adjusted to show every student on the bus, including the students directly behind the driver.

Students who are about to unload a school bus should remain seated until the driver tells them that it is safe to exit. After exiting the bus, they should walk to a position that is at least 10 feet away from the bus so the driver can clearly see them.

If your on-road driving test route does not include a railroad crossing, you may be asked to explain and demonstrate the proper railroad crossing procedures to the examiner at a simulated location.

In a school bus, the overhead rearview mirror is mounted directly above the windshield on the driver’s side.

Railroad crossings that do not have any kind of traffic control device are known as passive crossings. The decision to proceed across tracks at a passive crossing is entirely up to the driver.

Most commercial vehicles manufactured after 1998 or 1999 are required to be equipped with Anti-Lock Braking Systems (ABS). Many older buses are also equipped with ABS.

The danger zones of a school bus are areas in which children are most likely to be hit, either by another vehicle or by the bus itself. Such areas are located to the front, sides, and rear of a bus. Danger zones can extend 10 feet from every side of a bus.

During the on-road driving test, if your route does not include a railroad crossing, the examiner may ask you to explain and demonstrate the necessary procedures at a simulated location.

A pre-trip inspection should be completed in the same way before every drive. Consistency will help you learn all of the proper steps and decrease the likelihood that you will forget to check something.

When asked to make a turn during the on-road driving test, you must check traffic in all directions and use your turn signal.

Proper mirror adjustment is vital to the safe operation of a school bus. A bus's flat mirrors should be adjusted so the driver is able to see 200 feet, or four bus lengths, behind the bus.

The adjustment of mirrors should be checked prior to the start of any trip.