Over 95% pass rate when practice at DMV Practice Test

Alaska MOTORCYCLE DMV Practice Test 10

Take 16 practice tests for MOTORCYCLE is the best way to prepare for your Alaska DMV exam is by taking our free practice tests. The following question are from real Alaska DMV practice test. More than 95% people pass a DMV exam when practice at DMV Practice Test.

Number of Test
16
Number of Question
25
Passing score
20
13%
  • 0Correct
  • 0Incorrect
Not enough to pass :-(

Ouch! While you were on a roll there for a few questions, you didn’t pass this time. But I know this test, and I think you’ll pass next time. Really.

1. If you must brake and swerve to avoid a hazard, you should:
Do one, then the other.
Do both at the same time.
Always apply the brakes first, then swerve.
Try instead to use only the brakes.

If you must brake and swerve to avoid a hazard, you should perform both actions separately. Brake then swerve, or swerve then brake. Do not do both at the same time.

2. What does this hand signal mean?
/data/image/dmv_image/motorcycle/handsignal3.png
Slow or stop
Left turn
Right turn
Backing up

Instead of or in addition to mechanical turn signals, operators may use hand signals to indicate turns or stops. If an operator's left arm is extended straight out to the left, it means the operator plans to turn left or change lanes to the left.

3. Motorcycle riders should not rely on their mirrors to see what’s going on around them because:
Motorcycle mirrors are smaller than the mirrors on other vehicles, so you can't see as much.
Motorcycles, like cars, have blind spots.
Mirrors are never accurate.
Mirrors take your eyes off the road in front of you and they should not be used.

Motorcycles, like any other vehicle, have blind spots. Therefore, you cannot rely only on your mirrors to know what is happening behind you. Frequent head checks should be part of your normal routine.

4. When riding near stopped or slow-moving cars, a motorcyclist should:
Pull over and wait until traffic begins to move.
Ride on the shoulder to get through the area as quickly as possible.
Weave between the cars to get through the area as quickly as possible.
Not weave between the cars.

Riding between slowed or parked cars can leave you vulnerable to unexpected hazards, such as opening car doors or cars suddenly pulling into traffic. If a hazard arises, you will not have room to safely maneuver. Never travel on the shoulder of a road because other drivers will never expect you to be there.

5. When packing a load on a motorcycle:
The heavier items should go toward the front.
The heavier items should go toward the rear.
Mounting loads behind the rear axle is recommended.
Lighter items should be stored in front of you.

Loads should be positioned forward with heavier items toward the front of the load. Loads should be over or in front of the rear axle. Lighter items should be packed behind you.

6. When passing another vehicle:
You must complete the pass without exceeding the speed limit.
You may complete the pass in a no passing zone if the pass was started before the no passing zone began.
You may exceed the speed limit.
You should pass on the shoulder.

All passes must be completed within the posted speed limits and only in areas where passing is permitted.

7. When braking, you should use:
The front brake only.
The rear brake only.
Both front and rear brakes.
Either the front or rear brake, but not both.

You should always use both brakes every time you slow or stop.

8. If you think stopping your motorcycle will take longer than usual, you should:
Lengthen your following distance.
Shorten your following distance.
Leave the road.
Speed up.

Lengthen your following distance when traveling on a slippery surface. If it will take longer than usual for your motorcycle to stop, open up to a longer following distance.

9. When you are stopped, you:
Should remain in first gear.
Should remain in neutral.
Should remain in fifth gear.
Can remain in any gear.

Shift down through the gears with the clutch as you slow or stop. Remain in first gear while you are stopped so you can move quickly if needed.

10. Fatigue can be increased by:
Stopping frequently.
Riding in cool weather.
Being comfortable during your ride.
Starting a ride late in the day.

To reduce the danger of fatigue when riding, dress to protect yourself against tiring weather conditions, such as wind and rain. Limit yourself to no more than about six hours of riding per day and stop for a break at least once every two hours. Avoid taking artificial stimulants since you may experience extreme fatigue when they start to wear off.

11. Impairment from alcohol:
Begins with the first drink.
Begins at about half of the legal limit.
Occurs at the legal limit.
Occurs only if you have had multiple drinks.

As little as one drink can have a significant effect on the abilities that you need for safe riding. You can be impaired even if you are well below the legal blood alcohol limit. No amount of alcohol is safe to consume before riding.

12. To carry a passenger, your motorcycle must have all of the following, except:
A seat large enough for two people.
A set of foot pegs for a passenger.
Properly adjusted lights, mirrors, and tires.
A small sign on the back stating that a passenger is riding.

To carry a passenger, your motorcycle must have a seat large enough to fit two people without crowding. It must also have a set of foot pegs for the passenger. Be sure to adjust your motorcycle to allow for the added weight of a passenger.

13. In hot weather, wearing a riding jacket:
Can help protect against heat exhaustion and dehydration.
Is discouraged because it can cause heat-related problems.
Should only be done if the jacket is a light color.
Is not important.

A riding jacket and long pants should still be worn when riding in hot weather. In addition to their other safety benefits, they can protect a rider from heat exhaustion and dehydration.

14. Mirror checks:
Are unimportant.
Should only be done on long trips.
Should be part of your normal scanning routine.
Are not helpful since you can’t do anything about what is behind you.

Frequent mirror checks should be part of your normal searching routine. Additionally, make a special point of using your mirrors before changing lanes, when stopping at an intersection, and before slowing down.

15. When choosing clothes for riding, which of the following is not a good choice?
A jacket and pants that cover your arms and legs completely
Boots or shoes that cover your ankles
Gloves made of leather
A baseball cap to cover your hair

To protect yourself against injury, you should wear a DOT-compliant helmet; face or eye protection; a jacket and long pants made of sturdy material; boots or shoes that are high and sturdy enough to cover and support your ankles; and gloves made of durable material.

16. You should use a larger cushion of space:
When roads are slippery.
When it is sunny outside.
When it is colder than usual.
When you are following other motorcycles.

A two-second following distance is generally appropriate. Allow a larger cushion of space when riding under conditions that will increase your stopping distance, such as when the road surface is icy or wet.

17. When conducting a pre-ride check, be sure that:
The brakes make a loud squeaking noise.
The brakes cause some friction with the steering.
Each brake can hold the motorcycle.
Only the rear brake can hold the motorcycle.

Check your brake levers individually before every ride. Make sure each one feels firm and holds the motorcycle when the brake is fully applied.

18. When selecting a helmet, make sure it is all of the following, except:
Designed to meet U.S. Department of Transportation standards.
Snug.
Defect-free.
Attractive.

You should select a helmet that meets U.S. Department of Transportation and state standards; fits snugly all the way around; and has no obvious defects, such as cracks, loose padding, or frayed straps.

19. To adjust for added weight when riding with a passenger, you should:
Operate at a slower speed than usual.
Maintain a shorter following distance that you would if riding without a passenger.
Operate at a faster speed than usual.
Brake a little later than you would if riding without a passenger.

The extra weight of a passenger means that your motorcycle will need more time than usual to speed up, slow down, and turn. To accommodate the added weight, you should reduce your speed; start slowing earlier than normal; increase your following distance; and seek out larger gaps when crossing, entering, or merging with traffic.

20. When riding with a passenger, the operator should:
Maintain a longer following distance.
Increase their speed.
Deflate the tires to accommodate the extra weight.
Not warn passengers of impending hazards.

Because a motorcycle handles differently when under the weight of a passenger, an operator should maintain a larger space cushion when transporting another person.

21. Wearing which of the following colors can help you be seen by other drivers?
Black
Brown
Blue
Orange

Wearing bright orange, yellow, or green clothing can help make you more visible to other road users.

22. Engine braking:
Is illegal.
Is slowing down by turning the engine off.
Is slowing down by downshifting.
Is not encouraged because of the damage it does to the engine.

Shifting to a lower gear produces an effect similar to applying the brakes. This is known as engine braking.

23. When riding at night, how should your following distance compare to your following distance during the day?
You should allow a longer following distance when following another vehicle at night.
You should allow a shorter following distance when following another vehicle at night.
You should always maintain the same following distance regardless of the time of day.
Following distance really doesn’t matter.

Distances are difficult to judge in the dark because visual cues (like shadows and light contrasts) can be missing or distorted. You should allow a longer following distance when riding at night than you do when riding during the day.

24. When entering a curve, a group should:
Ride in a single-file formation.
Ride in a staggered formation.
Ride in pairs.
Ride on the shoulder.

While riding in a staggered formation is usually best, a group should switch into a single-file formation when turning, taking curves, or entering or exiting a highway.

25. When riding in a group, the best riding formation is generally:
Pairs.
A staggered formation.
A single-file line.
A pyramid formation.

A staggered formation is generally best when riding in a group. You should move into a single-file line when turning, riding in a curve, or entering or exiting a highway.

Your Progress
  • 0Incorrect (5 allowed to pass)
  • 0Correct
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25