Alaska CDL DMV Endorsement Passenger 2

When inspecting your vehicle's suspension, verify that leaf springs do not have missing or broken leaves. If at least one-fourth of the leaves in a leaf spring are missing, the vehicle will be put out-of-service until the defect is fixed.

When planning to turn left at an intersection, make sure you have reached the center of the intersection before beginning the turn. If you turn too soon, off-tracking may cause the left side of your vehicle to hit another vehicle.

When driving, it is important to be aware of what is happening behind and to the sides of your vehicle. Mirror checks and head checks should be a normal part of your scanning routine.

When driving under foggy conditions, lights cannot be taken as a reliable indication of where the road is. The lights may be coming from a vehicle that has pulled off the road.

When making a left turn, you should wait until you reach the center of the intersection before actually beginning to turn. Due to off-tracking, the left side of your vehicle could hit another driver if you begin turning too early.

If you encounter a driver who seems distracted on the road, you should give them plenty of room and maintain a safe following distance.

When examining the engine compartment during a pre-trip inspection, you should check the engine oil level, the radiator coolant level, and the condition of the hoses.

When accelerating, speed up smoothly and gradually so the vehicle does not jerk. Rough acceleration can cause mechanical damage.

Black ice is a thin layer of ice that is clear enough for the road surface to be seen through it. A road covered in black ice may look like it is merely wet. You should be very careful when temperatures are below freezing and the road looks wet.

When checking the tires as part of a pre-trip inspection, make sure the tires have sufficient tread. There should be at least 4/32 of an inch of tread in every major groove of the front tires, and at least 2/32 of an inch of tread depth on the other tires. Tires should not be mismatched in size and radial and bias-ply tires should not be used together.

Be sure that you are able to accelerate without first rolling back. Rolling backwards may cause you to collide with a vehicle or other obstacle behind your truck.

Be cautious when driving near people who are working on a disabled vehicle on the side of the road. They may be focused on the repair and not paying attention to nearby traffic.

When inspecting your vehicle, you should check the wiper blades for damage, stiff rubber, and proper securement. Clean the blades if they are dirty.

When stopping, it is best to gradually press down the brake pedal.

Gravity causes a vehicle's speed to increase when traveling on a downgrade. Adjust your speed before reaching a downgrade.

If your vehicle begins to hydroplane, do not apply the brakes. Instead, slow down by releasing the accelerator and pushing in the clutch. This will help you to regain traction.

Strong winds can make it difficult to keep a vehicle in its proper lane. Strong wind can be a particular problem when a vehicle is being driven out of a tunnel.

When arriving at a final destination or intermediate stop, a bus driver should remind passengers to take their belongings with them when exiting the bus. It is best for the driver to make this announcement before the bus comes to a complete stop.

Alcohol consumption impairs muscle coordination, reaction time, depth perception, vision, judgement, and inhibition. For some people, signs of impairment may begin with the first drink of alcohol. It is safest to not operate any motor vehicle after consuming alcohol in any amount.

Reduce your speed when traveling on surfaces that provide reduced traction. Reduce your speed by about one-third when driving on a wet road.