Alabama CDL DMV Endorsement Bus 2

When inspecting a trailer during a vehicle inspection test, ensure that its landing gear has no missing parts and that it is fully raised. The crank handle should be secure and the support frame should not be damaged.

When exiting your vehicle during the basic vehicle control skills test, you must face the vehicle and maintain three points of contact at all times. If your testing vehicle is a bus, you must maintain contact with the handrail. Exiting the vehicle incorrectly may result in automatic failure of the basic vehicle control skills test.

When exiting your vehicle during the basic vehicle control skills test, you must face the vehicle and maintain three points of contact at all times. If your testing vehicle is a bus, you must maintain contact with the handrail. Exiting the vehicle incorrectly may result in automatic failure of the basic control skills test.

While students are boarding a school bus, the driver should supervise the loading while watching all mirrors for any students running to catch the bus.

If you are asked to complete an offset back/right parking maneuver, you should first pull straight forward, then back up to the right. Your vehicle must be parked completely within the boundaries of the parking space.

A driver uses a look when they open their door, leave their seated position, and walk to the back of the vehicle to check its position. During the straight line backing exercise, a driver may not exceed one look. During any other exercise, a driver may not exceed two looks.

During the basic vehicle control skills test, there is no penalty for an initial pull-up; however, an excessive number of pull-ups will count as errors.

If a school bus driver forgets to stop where a student is meant to unload, the driver should not back up to the stop. Instead, they should follow established local procedures.

School bus drivers may only pick up students at official stops designated by authorized school officials.

Outside convex mirrors on a school bus are located below the outside flat mirrors. They are used to see a wide view of traffic, clearance, and students around the bus.

If you are asked to alley dock, you should first pull past the alley and stop your vehicle in a position that is parallel to the outer boundary. From there, you should back your vehicle entirely into the alley parking area. Your vehicle should be parked in a straight position within the boundaries of the parking space.

Students on a school bus should remain seated until they are told otherwise. It is unsafe for students to walk around the bus while it is moving.

In a school bus, the overhead rearview mirror is mounted directly above the windshield on the driver’s side.

When unloading students at a school, a bus driver must secure the bus by turning off the engine. If they must leave the driver's compartment, they should remove the key from the ignition. The driver must supervise the unloading process.

When checking a header board during the vehicle inspection test, you should ensure that it is secure, free of damage, and strong enough to contain cargo.

During the vehicle inspection test, you must check the power steering belt, water pump belt, alternator belt, and air compressor belt for snugness, cracks, or frays. If any of these components are not belt-driven, you must tell the examiner which one(s), and verify that they are operating properly, mounted securely, and not damaged or leaking.

In most emergency or crisis situations, students on a school bus will be safer and more easily controlled if they are kept on the bus than if they are evacuated. However, if staying on a bus will expose the students to risk or injury, the bus driver should escort them to a safe location.

Railroad crossings that do not display any traffic control devices are known as passive crossings. The decision to proceed across tracks at a passive crossing is entirely up to the driver.

On a school bus, the overhead inside rearview mirror is mounted directly above the windshield on the driver’s side of the bus. This mirror should be used to monitor students inside the bus.

The examiner will score the number of times your vehicle touches or crosses an exercise boundary line. Each encroachment will count as an error, resulting in points against your skills test score.