Alabama CDL DMV Endorsement Bus 1

If you are asked to alley dock, you should first pull past the alley and stop your vehicle in a position that is parallel to the outer boundary. From there, you should back your vehicle entirely into the alley parking area. Your vehicle should be parked in a straight position within the boundaries of the parking space.

Maneuvers that may be included in the basic vehicle control skills test include straight line backing, offset back/right parking, offset back/left parking, driver side parallel parking, conventional parallel parking, and alley docking.

Maneuvers that may be included in the basic vehicle control skills test include straight line backing, offset back/right parking, offset back/left parking, driver side parallel parking, conventional parallel parking, and alley docking.

During the on-road driving test, you must drive in a safe and responsible manner; wear your safety belt; obey all traffic signs, signals, and laws; and complete the test without any accidents or moving violations.

When exiting your vehicle during the basic vehicle control skills test, you must face the vehicle and maintain three points of contact at all times. If your testing vehicle is a bus, you must maintain contact with the handrail. Exiting the vehicle incorrectly may result in automatic failure of the basic control skills test.

It is critical to the safe operation of a school bus that mirrors be properly adjusted. Always check each mirror before operating the bus.

During the on-road driving skills test, you will be evaluated on your gear usage. Select a gear that does not rev or lug the engine; avoid grinding and clashing gears; and avoid shifting through turns or intersections.

You will be asked to change lanes during the on-road driving test. When the examiner asks you to do this, you should make the necessary traffic checks and use the proper signals before changing lanes.

Backing maneuvers that may be included in the basic vehicle control skills test include straight line backing, offset back/right, offset back/left, driver side parallel parking, conventional parallel parking, and alley docking.

The driver of a school bus should observe students as they enter or exit the bus to ensure that they are not caught in the door or handrails. It is also important to make sure the students have moved a safe distance away from the unloading area after they have exited the bus.

A school bus driver should always approach bus stops slowly and cautiously.

A school bus has blind spots immediately below the side flat mirrors, immediately in front of the side flat mirrors, and directly behind the rear bumper. Rear blind spots typically extend 50 to 150 feet behind a bus but can sometimes extend up to 400 feet, depending on the length of the vehicle.

Students who are about to unload a school bus should remain seated until the driver tells them that it is safe to exit. After exiting the bus, they should walk to a position that is at least 10 feet away from the bus so the driver can clearly see them.

In a school bus, the overhead rearview mirror is mounted directly above the windshield on the driver’s side.

The examiner will score the number of times your vehicle touches or crosses an exercise boundary line. Each encroachment will count as an error, resulting in points against your skills test score.

Backing a school bus is strongly discouraged and should only be done if there is no safe alternative. If you must drive in reverse, be sure to follow all proper safety protocol.

Crossover mirrors are used to help a school bus driver see the danger zone area directly in front of the bus, as well as the danger zone areas to the left and right sides of the bus, including the area from the front of the bus to the service door.

Once students have boarded a school bus, the driver should wait to move the bus until all of the passengers are seated and looking forward.

When inspecting a tractor/trailer coupling, look into the fifth wheel gap and make sure the locking jaws are fully closed around the kingpin.

During the external inspection portion of the pre-trip vehicle inspection test, you must verify that the steering box is securely mounted and not leaking.